73-Cudah2's latest activity
-
73-Cudah2 replied to the thread Head Gasket leak.Well after doing some digging around I found that the exhaust valve is made like that. I think I will still send the heads in and have... -
-
Ricks72Chlgr440 is correct, you're in this deep, check everything out and machine/replace as necessary. May as well do it right and it...
-
The project will likely cost you more than you thought, but don't go cheap and try to cut corners. Build it the way you want with...
-
73-Cudah2 replied to the thread Head Gasket leak.Thanks Xcudame! My brother in-law said he ground the valves to have a triple seat. They look ok but I was going to do a lap valve job...
-
-
73-Cudah2 replied to the thread Head Gasket leak.Man the more I look at the more I find. Pulling a few valves and this one looks bad. So you replace all valves if you have a bad one...
-
-
Chain for sure , Cloyes is good , I use JP performance chains
-
I've cleaned water passages on bare blocks with a pressure washer. Without tearing it completely down because water will get every...
-
73-Cudah2 replied to the thread New from WNC.Welcome to the site! I still have my first car 1955 210 2 door when I was 15. My Dad picked it up for $600.00 it was just a shell but...
-
73-Cudah2 replied to the thread New from Switzerland.Nice looking Challenger! Welcome.
-
73-Cudah2 replied to the thread New Guy in NJ.Great find!
-
73-Cudah2 replied to the thread Head Gasket leak.Thanks for the info. This has turned into a bigger job than I wanted at this time, but here I am. Thanks again.
-
Yeah for sure. Cloyes billet are nice ones. Hate to say but my Edelbrock one stretched after about 2 years. You can also fit the chain...
-
73-Cudah2 replied to the thread Head Gasket leak.Looks like I may need to replace timing chain and gears? What do you guy's think? Thanks!
-
-
73-Cudah2 replied to the thread Head Gasket leak.I pulled the engine and bearings look good, just cleaning up the block and heads. I am replacing the engine frost plugs and found some...
-
-
Believe it or not easy off oven cleaner works on some undercoating.
