Recent content by Glow Worm

Thank you. Don't mind a small gap but the 1" I'm seeing is not good.

Who sells BRUSHED trim rings to fit the 8 inch wide Mopar rallye wheel? I have purchased the ones for the 7 inch wide wheels from Coker, but I don't see anything for the 8 inch wide wheel. Thanks!

Thanks! I'll check it out.

Sounds easy enough! Thank you.

Anyone know if there is a "Kit" available to restore a EBody OE air conditioner system?

Can the radio in a 72-73-74 eBody be removed (fairly easy) without removing the dash? Can the clock be removed without removing the dash? I have done "Dash Diving" in earlier models and I know it is usually not easy or fun. Thanks for your input.

Anyone running 400 horsepower thru stock 1972-74 manifolds?

I would be happy with that!

Any earlier than 1972?

OK Not too far from Portsmouth. I am looking for some exhaust manifolds for a 340.

Where, exactly, are you located?

Where is the best place to buy nice, inexpensive battery cables for my 73 Cuda? I don't want the clamp on ends and not looking for Concourse stuff. I want them to look nice and clean and to function properly. Thanks!

Are there any "less expensive" re-pop exhaust manifolds available to replace the 69-70 manifold numbers 2863549 and 3418623? Anyone running 350-400 horsepower thru their/with their original 1973 factory e-Body manifolds? My engine builder says get rid of the 1973 factory originals on my Cuda 340...

Thanks to all. I am in the process of "borrowing" aset of 15 inch wheels/tires that are taller than what I have. We'll see what happens.

I'm thinking of going from 14 inch to a taller 15 inch on the rear. That might be the best/cheapest route.