Recent content by Lemon twist Cuda

I am looking at your dash. I see aside of your ac controls is a rear speaker knob. I do not have ac in my car but I am looking for a new rallye dash heater control panel, but every piece I see doesn't have the rear speaker hole in it. Can you buy the panel with rear speaker hole already cut...

My temperature gauge spikes as soon as I start the car, but after a minute or so it comes down. Not long then it goes back up again, so I tried this test with the light and the engine running. When the light is on the gauge spikes and when the light is off the gauge drops. But each cycle is...

I am looking for 1 stud with the piece of metal attached that go's though the tail light housing that mounts the housing to the back panel. I have 15 but need 16. Nobody sells one so I would have to buy a whole kit (nuts and bolts) for around $50.00. Anybody have an extra one. Thanks, Randy

I have one that looks right like that except mine has a black vinyl top, a center console and rally wheels.

Thanks

I asked someone on ebay if they had a date coded 73 mopar jack. They said they have a 3C, 3F and a 3G. What do the letters mean. Thanks

You people on here have made me go look harder at the brake pedal and it looks like I am missing the pivot assembly. I didn't know I was missing that. Guess what, another piece that the restoration shop didn't give me back. Looks like it will cost me about $100.00 to get a pivot assembly that I...

Where does the hole in the push rod from the master cylinder that comes thru the fire wall hook too. Doesn't that special bolt with the O ring go thru the hole in the push rod.

73 Cuda 340. First restoration shop ripped me off. Shop even has lost a lot of my parts so I have nothing to go by. Here is my problem. New master cylinder with power brake booster has been put in. The push rod that goes to the pedal needs a bolt. Bought a brake pedal bolt that fits a 70-74...

The restoration shop that took the bottom apart has seemed to have lost the anti rattle brake clips. The only place I have found some for my 73 Cuda is Jim's Auto. ( 4 clips for $124.95 ). Anybody know of another place that is reasonable in price. The shop said they would look for some. I think...

Application Notes: In 1970-74 Mopar used 2 types of brake lines. Type 1: Right front line is routed under the frame rail on all 1970 models and select 1971-74 model E-body vehicles.Type 2: Right front line is routed over the frame rail on certain 1971-74 model E-body vehicles Didn't know...

The restoration shop put new black rubber splash pads on above the rails near the A arms in the front wheel wells. The pad on the right front has a hole and a slot through it. The person restoring it does not know if brake line runs though hole or under frame. Doesn't know what the hole would...

I have a 73 Cuda with disc brakes up front. Do the brake lines go above the rail or below the rail. Had the car at a shop to do the bottom. Long story short, they were taking me for a ride. Told them just to get wheels on it and let me push it out. They couldn't find some of my old parts. I...

73 Cuda 340 4 speed all original in the process of restoration.

This is my restoration so far on my Cuda.