Search results for query: *

e body shifter, rods and tabs work ,,i put one in my 70 challenger just had to flip the rods,if not od ends up being 3rd ..hth

i think thats 340,,but should fit 440 how much you asking ?

hello thanks for input i believe the 383 one is different it has a hole in front for a support bracket,, yeh send me some pics ,, thanks in advance

hello looking for a 440 4 barrel shaker base plate,,thanks in advance

hello im looking for rear trim for 70 challenger and trunk trim if available...shaker 4bl base plate and passenger 70 big block valve cover,,thanks

hello got a shaker door for a project put it next to one i have and it looks like a repop to me guy says it oem....did mopar use different vendors for shaker parts? thought it was fram in canada that made the shaker parts..any input would be appreciated thanks in advance

hello try drilling out idle mixture plugs on front and rear carbs so you can adjust them with vaccum guage installed for highest reading,,helped on my setup which is close to your build..hth

hello looking for cut up six pack air cleaner base just need center section where carbs sit....thanks in advance

hello looking for 70 440 sixpack kickdown linkage and underdash a/c wiring,,thanks in advance

hello thank you fellow members for your input ...i had put the link paypal resolution and they ruled in my favor today ,,im just out the 60 machine shop charged me...never heard from the seller..... thanks again

hello yes thats member,,still no response and i emailed her other email address that also goes to her phone,...heres last response i had from her...prior to this email which took awhile to respond, reason it took so long she stated there was an death in family... " I have spoken with the...

hello and thanks moparleo..still no response from member and i told the member i was going to post pics and ask members for their thoughts...

hello purchased some heads from a member here...after they were being shipped ,,was emailed by member that the heads have minor pitting that was just noticed but shouldnt be a problem...well after i got them i sent them to machine shop to get checked...they call me and tell me heads are...

pm sent