this is a gap on the left side upper windshield trim. this is the original trim. --car never wrecked/original owner---. right side fit ok. what can I do to fix this problem????????
know where these go, but what is purpose--extension of rain rail? found screw hole on right side, but left is gone. tried to find it, can't remember if it was bond-oed over. may have to drill a new one once positioned.....next---how far down does the rainfall go down in the front. lined up...
this goes behind the window crank. only found 2. if I remember there were also behind the rear handles. what is the proper name and who might have them. 71 Challenger
starting on the drivers side door panel. examined closely for a indication for the joy stick position--no such thing. have clip in place to hold cables in place. --- Need dimensions for placement...........right side panel on. bit of an ordeal to get those bottom spring clips in place
is the door pull attached to the door panel, or is it a separate piece held to the door frame by 2 screws????panel fits very goo--test fit--- does the rubber weather seal go on top or under the panel. anything I need to know before final install??
how is the cable routed. tried under window--nope---to the front side--nope. there is a small clip that goes somewhere to hold the cables in place--where??? Also need to have location for hole in door panel to mount the actuator
getting ready to install the interior door trim. painter the door pulls.,, have the hem arm rests. pretty good shape other that dirty looking. scrubbed them with Dawn, but still stained....can these be painted. different material that the plastic parts.
put headers on my '71 Challenger small block. the ends of the pipes were tight against the torsion bars on both sides. no air gap at all. friend gave me some manifolds--part #53010187 left and 186 rt side. are these good bad or ugly. I know its a matter or personal preference....Suggestions...
cannot get power to the fan motor. according to the wiring diagram all wires are in the correct position..cannot get power to the blue wire at #4 position on fire wall harness. have good ground, hot from battery to fan, it comes on
found left hand a/c trim with a/c vent.it also has a piece with rear speaker on it. also the trim has some sort of rough finish on it. the original was a slick finish.. ?? can that rough finish be removed or should leave well enough alone. also what are those 2 holes for??
putting the controls back together--windshield wiper stays on, no response with the switch. there are 7 wires on the switch. plugs match to connectors.....I have a color coded wiring diagram and it does not show a 7 wire switch. this is also a new rally dash harness. 2 wire plug is---is a red...
pad #5. same problem as before. Gap between pad and trim. trim is OEM. saved when I disassembled car. pic of trim is ic correct position. assl pad studs are in the right position\
wanting to replace the wiper gaskets on the pivot posts. I can do the one in the center, BUT the left side is going to be difficult at best. any suggestions would be helpful.....
NEXT...new T shifter opening is 3/64" to small will not slide over the shifter--have to return. is there another...