I have no experience with Dynacorn quarter panels but. I returned the AMD trunk floor extensions and replaced them with Dynacorn units they are of higher quality and include components not found on the AMD units. I also used the Dynacorn trunk floor and also found it to be of higher quality. Now...
My simple response is also the most impossible. I could just stop by and we would review the problem together, except your in Japan! I am a retired career body and frame tech. typically when faced with a like situation the short answer is try to lower the deck lid and raise the qtr. panel. But...
The drip rail is a real POS and does not follow the contour correctly. I ended up only used about the rear 10 inches of it and spliced it together with the existing original. Many of the parts I purchased from AMD had to be altered or were returned as they were unusable. Many of the original...
I purchased AMD then later the Dynacorn Qtr. extensions the AMD ones are missing a bracket and do not include the parts for the bumper jack mount. also the Dynacorn seem to fit better
For decades now manufacturers have had the VIN stamped deep inside hidden areas that are difficult to access. If you can't do the time, Don't do the crime. RIGHT!
When you remove the id tags from one car and place them on another car. In the eyes of the law you have committed Federal, State, and most likely local criminal fraud . Despite what good intensions you may have. and it does not matter even when you legally own both said cars. How to do this is...
Yeah, this was never the plan when I started. LOL. it had some rust between the drip rail and roof skin by the qtr. window had to remove the roof skin to repair the spot and then found much of the structure under it was rotted thru so those panels had to be removed the rust cut out new parts...
When these cars where built the only paint on them was what you could see and only where the painter could reach. Simply put every internal structure was left as bare metal. After removing rusty panels, soda blasting the surface and priming with an acid based zinc chromate primer. I think your...
Well then, I recommend that you cut the complete roof and rear shelf off a donor. you will be better off than trying to piece one together. If you have good welding skills you should continue your project as planned. Sincerely wish you best of luck.
Given what I can see in these few pictures. I have to question what is the bottom of the car like? How much of it even exists? If the rest of this car is in similar condition. I have to say don't waste anymore of your time. the cost or...
I have a couple NOS TCI torque converters still new in the box, Wilwood brakes with aluminum hubs NOS but can't find the rotors. also have 355 suregrip 789 case diff.
Yes, I have all of that stuff but some of it I may have sold to someone else on this forum that needs a K-frame. they are still attached to the K-frame. That sale is expected to happen in couple days from now. I will contact you afterwards as I'm not sure what will be left. And I have other 70...
It is really hard to give a fair answer without being there to see it and measure it etc. I do know that the aftermarket door hinges can be an issue I replaced one on the right side of the car it fit so poorly no amount of making the holes bigger was gonna work. they simply are to wrong size...
Yeah that's a mess, Sorry but have to call them as I see them. Absolutely rust under the old body work and the old body work appears extensive and expensive to repair. Good luck!
Agreed it is seems strange as the cars floor pan does not show the signs of damage I would expect. Given how far internally your damage is located my only guess now would be this somehow happened post disassembly. Bottom line is it really doesn't matter at this point how or why. you still have...