Results 1 to 3 of 3

HELP: Hydraulic Clutch Setup for stock pedal.


-
  1. #1
    New Member hogpowr's Avatar
    Join Date
    Mar 2012
    Posts
    19
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default HELP: Hydraulic Clutch Setup for stock pedal.

    Hey guys, I just put in a tremec 5 speed into my 70 Challenger. I decided to go with a Hydraulic clutch/ Throwout bearing. Very tight space for me by the clutch pedal. I've been looking for a nice hydraulic clutch conversion to use my existing pedal. I don't want to completely re work the fire wall? Has anyone done this and if so, did you make or buy a bracket? I can weld and FAB. so if you can help, I can probably make it.

    Help and ideas would be very much appreciated. Even a picture or two!!

    Thanks Rob

  2. #2
    Senior Member
    Join Date
    Dec 2008
    Location
    Panama
    Posts
    1,183
    Thanks
    3
    Thanked 44 Times in 43 Posts

    Default

    There are 2 that bolt into the oval hole in the firewall & the pushrod connects onto the stock pedal , Keisler , bad system takes hours to bleed the air out .
    The second system is far better ,I cannot remember the name of it , BigBlue73 on the CC site works for Classic trans conversions / Hurst & has access to the better system

  3. #3
    New Member hogpowr's Avatar
    Join Date
    Mar 2012
    Posts
    19
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Default

    Thanks. I already bought a willwood master cylinder, but I can return it or perhaps it will fit. From what I've seen most of the small master cylinders have same bolt pattern.