Surfcuda's latest activity
-
SIIRC, the nut on the backside is not fixed in place. Once you loosen the bolt, you should be able to move it. May be stuck in place...
-
SSurfcuda replied to the thread Door Adjustment.Thanks Cuda Joe, looking at the Striker Post it appears to just bolt in with a fixed nut on the backside. Doesn’t look like it can be...
-
SI had the same problem with my car. I had purchased brand new door weatherstrip in the 90's from AM SoffSeal. After hours of adjusting...
-
SThe make all of the adjustments with the hinges. The door latch is just a light stamping and not intended the have much constant stress...
-
SSurfcuda replied to the thread Door Adjustment.Thank you. I’m just a backyard engineer and was thinking that either the Striker Post or Latch Assembly would pull the door in as...
-
SThe striker post is also adjustable. You may need to adjust it in toward the interior to pull the door in more.
-
SNo expert on this, but that is what I was thinking too. My experience on this is limited, but if the entire rear edge is proud, as...
-
SSurfcuda replied to the thread Door Adjustment.Moparleo, Thanks again! Your info is always insightful and welcome. 🌴
-
SSome information
-
SSurfcuda replied to the thread Door Adjustment.Appreciate the info MrCuda. I was working on the door seals when I noticed the door wasn’t aligned. The gaps are pretty good around the...
-
SThe door latch is fixed. You will have to adjust a hinge, probably the upper. The door need to come in a bit too. How is the fit to the...
-
SMy passenger side door does not align when shut as shown in the attached photo. The door needs to come in about a 1/4 inch. Before I...
-
-
SSurfcuda reacted to moparleo's post in the thread Question on door latch pin in quarter panel jamb, ‘72 ‘Cuda with .The door should not move up or down if the upper & lower hinge pins are tight to the hinge. If it was tight, the door would not latch...
-
SUp front I run an MT 26x10 tire on a 15x8 wheel with 4.5" backspace. Fits well. BTW, that about a 255/60 in metric terms. I test fit...
-
SThis is me, I've been moving for the last month and a half and I'm not set back up yet, I should be in another week maybe two at the...
