70 Challenger Rocker Panel Molding

RJHJR · Nov 18, 2019

Looking for information to properly locate the rocker panel trim molding on a 70 Challenger.
Does any have that information of can you measure it on an existing car?
Thanks, Bob.

AUSTA · Nov 18, 2019

What do you need the hole position for the clips ???

RJHJR · Nov 20, 2019

AUSTA · Nov 20, 2019

from 1st hole at front see 5 1/2 from that hole a hole every 9 1/2 inches 5 in total
All holes 1 7/8 down from flat of door gap
not sure what the holes are in the rear quarter will check the 2 x front guard holes when i go to my factory