Afternoon all, I'm installing my rear sway bar on my 72 Barracuda. It came off of the car so I know it should go back on. I'm having problems bolting the bushings on the long bolt. There is no thread to screw the nut on. If I squeeze the bushings together i can see the threads on the bolt. I'm...
Good afternoon all; looking for the correct red paint for the trim on my 72 Barracuda. I tried Totally Auto but I'm getting no response. See attached pic.
Much thanks in advance.
Good morning, I'm looking for a 3 speed wiring harness for my 72 340 Barracuda. I can only locate ones for a 2 speed wiper. Any help or suggestions??? Can I modify a 2 speed? Need urgently.
Thanks ahead of time!!!!
Hi all, I'm looking for a good used or NOS a/c liquid line for my 72 340 Barracuda w/air. It's the line that runs from the condenser to the drier on the passenger side, p/n 3502233. The one I received from a Florida firm is not the same configuration as the one I took off and can't find when I...
Can anyone help me find a clip that goes on the end of the carb/transmission rod kick down lever. My car is a 71 Barracuda 340 , 727 transmission, all factory. My parts catalog shows p/n 2946640 b/c crank to carb rod. Any help would be appreciated!!
Tom
Hi all, I'm finishing up a restoration on a 72 340 Barracuda w/air. Can anyone recommend a source the sells correct vacuum lines or line kits for my car. Thanks for the help in advance.
Help, help!!!
The 72 Barracuda I'm restoring is missing the bracket for the water valve. I've done some research and the hole locations on my fender well show that the attached bracket (pic) is correct. I have other brackets, but I don't want to drill new holes. Any help locating one similar to...
I'm finishing the restoration on my 72 Barracuda, 340 auto. I want to keep the factory appearance on the 340 motor by using orange MP P4529797 7mm wires. The comments I hear about these wires is that they are too short to fit properly. Does anyone have a recommendation as to what wires to...
Afternoon All,
Need some help locating a heater box to dash seal p/n 2936608. 72 Barracuda a/c evaporator box to dash seal. Any help is greatly appreciated.
Afternoon,
Need some help with muffler options. Have a 72 Barracuda with a built 340 motor, 70 H.P. exhaust manifolds. Installing 2.5" exhaust and was wondering if anyone has experience using Dynomax VT mufflers. I hear some complaints about the muffler being noisy due to the internal valve...