Search results for query: *

I am looking for a pvc valve that will work on my 383 that has 6" hg at idle, engine vacumm is max 12"hg at highway speed. I currently have a stock pvc valve but its really messing up my idle due to the constant "vacumm leak", it won't idle in gear and after 20+ years of putting it in neutral...

Whats the deal with all these companies who sell leafspring wedges recommending that you bolt the wedge to the leagspring pack? Do most "newer" cars/trucks not have a long/tall enough leafspring locating dowel? I recently lowered the rear on my '74 challenger, making the car sit level in...

Heres a list of cars that have the same wheel bolt pattern and center bore as our ebodies. Keep in-mind that wheel backspacing will need to be confirmed as rim offset is usually more then the 4 1/4 or 4.5" backspacing our rides had from factory. This list just means that the wheel will fit on...

Back in the day I replaced my door hinge pins & bushings. Ever since I replaced my steel doors with fiberglass ones, my driverside upper door hinge pin keeps creeping up. One/close the door a few times and its moved up almost a 1/4 inch. Any tips or real fix for this? I'm starting to think about...

I am replacing my speedo gear (tranny is a 1976 B727), going from 25 teeth to 37 teeth. My housing however only has the markings for the 21-25 tooth and nothing else. The new housings don't have a alignment mark for 21-25T but do have a blank spot on it. Can I assume this spot would be for the...

My driverside strut bar is bent and I am thinking about trying to straighten it. Does anyone know if these bars are heat treated?

Anybody have any tips on how to get the bottom windshield moulding to sit nice and flush with the windshield? When my wipers park the passenger wiper blade catchs the moulding and hooks on. Driverside is not that bad but could be better. Can i shim the screw side up/ or do you silicone the...

I was going thru my used sparkplugs and noticed I've been using 2 different reach lengths. 3/8" and 3/4". I have a '71 383 with 2406516 cylinder heads (1964-67). I believe the machine shop installed Champion RN9YC plugs (3/4 reach) and I have used Autolite 56 (3/4 reach) and currently have...

Anybody know what the thrust angle specs are? I can't find anything in the 1970 & 1973 Dodge manuals. I had a "brain fart" when I touched/adjusted my toe-in/out and forgot to take any measurements. Then I went and finally centered my aftermarket steering wheel so eveythings slightly out. I tried...

Anyone running a tranny temp. gauge and a aftermarket cooler? My question is where did you mount the temp. gauge sending unit? I have a 383/727 and a aftermarket engine rad that does not have a internal tranny cooler. I have a mopar performance deep tranny pan which has a spot for a temp. gauge...

Hey fellow e body enthusiasts, thought I'd join this club and share or tap into the knowledge that's out there. I own a 74 Challenger, 383/727. Owned the car since '96 and have totally redone the car. It was a factory 318 car but a previous owner had blown the transmission and replaced the...