Can anyone tell me what drive gear I need. All i know is it's a sure-grip 3.2 slap stick automatic in a 318 engine out of a 1985. don't know if the differential is a 2.76 or 3.23. took in in to a shop they could not help me. My problem is with the speedometer. Once I get up to about 45 mph it'll...
I could use a little advice again. Speedometer reading jumps around a lot. Had the speedometer worked on and new cable installed, but still the same. Could it be the drive gear ? And if so will the fluid pore out when I take it out to replace it.
Can anyone tell me if the back of the speedometer where you hook the cable to has any kind of protruding lip on it? The reason i'm asking is the cable keeps falling off. Tried really pressing it on and broke the plastic clip on cable. Bought new one but before I try to put on, I want to make...
Haven't tested starter yet. Car started fine til I touched the starter relay and caused a spark. Since then car won't start, no sound what soever. Replaced starter relay and voltage regulator, still nothing. Could I have fried the starter ? If so where to buy ?
Getting 15.6 volts from battery when car on. This seems way too high what do I look for as the problem ? 12.4 with of. Voltage regulator ? It's on a 1970 challenger
Hey guys, Trying to remove center automatic console. I've removed two screws inside the console door this freed up the back end, also a couple of Philips on the side, but the front won't break free. Someone told me there was two screws in front of the shifter but I don't see them. Anyway its...
Need to install voltage gauge to replace ammeter. Outside of hooking it to a 12 volt power source & ground to metal frame, is there any specific place to to pick up power source ? And also is there anything else to be disconnected. I just did the ammeter by-pass & soldered the two leads together...
I had a couple of dash lights out and the entire light bar out. Fuse for the instrument panel is good but no power. Not the bulbs. Did the ammeter by-pass hoping to fix problem. Still nothing. If I buy a new harness should I buy just the dash harness, or do I need engine & dash harness & will...
Can anyone tell me if I could use an all copper butt connector for a wire splice ? And also can I connect the power wire from the new volt meter to the ammeter wires that I disconnected and fused together as an constant power source. These copper butt connectors I was going to use for the two...
Hey guys, I could use some more help on my electric problem, not getting any power from the fuse block instrument lights. changed fuse not the problem. I want to pull wire harness from the bulkhead to clean. How do I go about it ? Can I pull clips back and just pull plugs out or do I have to...
Tested the horn with different power source. It does work, but does'nt work when pushing in center cap on steering wheel. It seems to be missing relay. Is the relay the type that just plugs into the fuse box ? It's for a 1970 se challenger.
Hey all you great Mopar guys I could use some help. Not getting any power to the dash light bar, also from two of the gauge lights. The orange lead bullet connector is plugged in, but no power coming out of plug. Bulbs and fuse are good. I've cleaned up the dimmer switch the best I could. I...