Looking for a complete set of small block pulleys. Will be set up with just a alternator and power steering pump. Also need the brackets to mount alternator and power steering pump and lastly need the motor mount brackets for the block. This is on a 340 going in a cuda. Let me know.
Can this be done with the w2 race heads and the different angles. I’m not having any luck finding the w2 for the stock block. I do have a set of the racing w2’s and a set of the t&d rockers etc.
Anybody know the part numbers thru the years of the w2 heads and intake. I noticed older heads don’t have the same part number as the news listed at kegs or summit. This is for a stock block application. I’m hoping to find a set at the mopar nationals coming up.
Looking for the trim clip that covers the seat belt on the quarter panel for a 74 Barracuda. I’m not sure if these are reproduced or not or if these are a 74 only part.
The whole assembly is missing for my 74 Barracuda. I do have the plastic ductwork but it’s the vents that are missing. I see some are saying that 71-74 b bodies are the same. I found a couple of them but will they fit right in the factory spot. I see most of them mounted in a longer set up
I’m looking for the lh and the rh corner trim. The lh piece that has the vent and houses the hvac controls. The radio trim bezel. The cover that goes on the bottom of the steering colum and I believe there is two more pieces that go below the steering column on the dash. Please pm.
Looking for black a pillar trim both sides
The full 8 piece interior trim set that goes around windows headliner etc.
both kick panels in black
Both fender splash shields.
Both mirrors. Prefer paintable ones.
Please pm me if you have anything.
Can anyone tell me how many 318 speed cuda's were built and how many 4 speed cuda's were built. Would a four speed ever have been put behind a 318. I'm interested in the actual cuda model. Also can anyone tell me if the factory stripe that ran the full length of the car was painted on or a decal...
I've been researching cylinder heads and such for a little while. People say the magnum heads and block are a good choice. Is the magnum heads and block only available on the 89-92 360's or I've seen some say you can go up to 2007. I'm a little confused because everything unread gives different...
I was wondering what kind of hp gains a person could pick up by bolting on a set of w2 heads vs a set of let's say j heads. Would you see any gain or would a cam change be in order to get maximum hp out of the setup. Would a person normally go with a higher lift cam if they did the swap. I'm...
I recently bought a 74 cuda that's in pieces. Besides the obvious body work that needs done. The thing is completely tore apart and put in boxes. Can anyone recommend some service manuals or diagrams that have part numbers and locations of the parts.