Looking for the correct distributor hold down for my 1970 225 Barracuda

[Mopargyrl70]

I'm looking for the correct distributor hold down for my 1970 225 Barracuda. Did a tune-up and found the distributor is moving all over the place. The hold down bolt is tight. I found a claw style hold down on ebay, but read about a flat hold down on the Slant 6 forum. Appreciate any advice or photos of the correct part. Thanks!

 

[moparleo]

Did you just replace it or has it been loose for a while ? I thought the 6 cylinder used a different clamp than the v-8.

 

[halifaxhop]

I have them. it is a stamped metal hold down