• Welcome to For E Bodies Only !

    We are a community of Plymouth Cuda and Dodge Challenger owners. Join now! Its Free!

Recent content by Curt J

  1. Curt J

    New windshield glass

    Looking for new windshield with green tint. What’s everyone been ordering and happy with?
  2. Curt J

    Looking for my F440 HP

    I know this is a long shot. The car is a 70 R/T FC7 JS23UOB202817 It runs and drives fine with a 76 440. But I’d like to find the original 440. The party I purchased it from said it was a Missouri car. Looking for the block or engine. Thanks CJ
  3. Curt J

    FOUND 8-Track lower dash trim

    rbbuno3, Tonymopar had one. Thanks for the tip.
  4. Curt J

    FOUND 8-Track lower dash trim

    Will do, thanks!
  5. Curt J

    FOUND 8-Track lower dash trim

    I'm looking for the lower right dash trim piece for an 8-track for 70 Challenger.
  6. Curt J

    Need advise for rear speaker switch.

  7. Curt J

    Need advise for rear speaker switch.

    More
  8. Curt J

    Need advise for rear speaker switch.

  9. Curt J

    Need advise for rear speaker switch.

    Video not uploading how about pics.
  10. Curt J

    Need advise for rear speaker switch.

    Here's the video..
  11. Curt J

    Need advise for rear speaker switch.

    I'm including a video of my dash with what looks like previous owners remedy for a new stereo. My car is 8 track, 3 speaker dash, rear speaker equipped. It looks like some wiring was cut out from the drivers side eliminating the rear speakers and switch. The switch and wiring are still there...
  12. Curt J

    E-Body Steering Column Part 4 (Final Assembly)

    This is a great video series and I'm at the reassembley stage. Thanks for the tips.
  13. Curt J

    E-Body Steering Column Video Part 1 (How to Identify)

    Good info, Thanks!
  14. Curt J

    Manifold heat stove

    Does anyone make a complete kit for 70 Challenger w/440? I've seen a few pieces here and there but would like the works.
  15. Curt J

    70 Challenger torsion bar support fix

    The previous owner chopped this up pretty good to install a manual trans for some reason. I have an old trans hump sheet metal piece with partial cross member that should weld in place fairly well. It will take some fitment to get it right. If not it looks like I'm shopping for some parts at AMD.
See more
Back
Top