Recent content by Muddytruckin

Thank you for the link!

I know the end play is adjustable on the passenger side, but does that also affect the drivers side end play? I do not have a FSM. I should try to get one though.

i had to changeout the drivers side inner seal due to leaking. Greased the bearings, Put the new one in no problems. Placed the steel gasket/shim on, slid axle back in and bolted it up. I now have zero play. I understand it's not adjustable but figured I have just a little play. I did not put...

How do the espo +2 compare to the ride height of a super stock spring and how is the ride? What size is the tire in your picture?

Got around to taking the coils off to see ride height. Can't get two fingers between the tires and the quarters.

A pic of the setup

i have a 73 challenger with a 440. Looking for new leaf springs. Thinking of going with the 3300lb springs in the car. The car is full weight so probably about 3600ish. Would that spring selection help it not ride like a dump truck or sag in the back? I currently have XHD springs, some...

I figured the breather would have some vacuum due to the pcv being hooked to the carb base and creating a vacuum to get rid of crankcase gases/fumes

Have the pcv installed and readjusted air idle screws to lean it back out to 13.5. Should I be able to feel a noticeable vacuum putting my hand over the breather vent?

I actually thought the breather was the pcv valve and had that going to the carb base. There's nothing on the driver side valve cove but a hole where the pcv should be. Good to know. my air cleaner doesn't have any ports for hoses so I'll be putting a filter straight on the breather.

so I was running without the pcv valve hooked up and had some smoke coming from the breather. So I hooked the pcv up and had to adjust the air idle screws by 5 turns each to richen it out to 14.5 at idle, I have an aem Uego sensor So I think the pcv is bad or not even inside. What is supposed to...

Yes there is a spring in there. I'll probably get a cheapie water pump for $30 and put it on. If I can see it pushing water through the rad good, if not I'll get a new rad. Thanks for the tips on what to look for!

I just had this problem today. I put in a new starter relay and it did the trick

Also won't be able to hear the bearing over the gear drive.

Yes, it's running hot. She's not road ready yet so i had it running in the driveway and shut her off when it got to about 215-220. Thermostat is new and I drilled 3 small holes in it. Using 1 14" electric fan.