Recent content by 1fastcuda

Got it Fixed Had a freind come up and found out the Power Valve in the carb was bad. When we pulled the carb of noticed that the gasket had gas all around it. Base of carb was gas wet to' So we put a 1in spacer on the ld340 and Put it back together Got it running and had know hesitation and vac...

I have plenty of gas in the carb shoots right out. This carb has 2 air mixture screws. I've read that alot of carb's have 4 would that be a problem. Looking at different options before i have to tear apart. Thanks

Plugged off brake booster and carb got about 9in vac at 1000rpm. Starts right up no problem. has a holley 750 not a double pumper. You guys say degree the cam if its starting right up would that still be the problem. My vac gauge bounce's around like 7-10 My freinds chevy has 15vac and very...

Ok I will been working on the timing Today got vac at 10 at 1000rpm. my initial timing is at 10 deg it starts right up when warn so must be close. there's no starter drag like if timing was off. checked vac leaks found none. At idle was i step on it there's quite a hesitation ( quite a...

I have the timing on the money. My vauccum reading at 1000rpm is 7 bad checked for leaks found nothning. Deciding if i should go to a non vaccumm adv dist. Would this help??? The stock dist I have came out of a 1977 dodge truck. Thats what i had to use at the time. Not sure what to do thanks

have timing set at 10 just when i take off alittle stumble then gets better once you get going.is there a better way to time the motor without a degree wheel now.?? What would be a good number to set timing at. can you tell me would it be better to buy a after market distributer and coil to...

Hi Been having problems with hesitation on take off. Great at higher speed. This is a new restore 70 cuda 340 4 speed Has stock crank Eagle rods trw pistons x heads ld340 intake stock valve train. Running a purple cam 270 484 108 50 has 3.55 8 3/4 489 case Has Holley 750 carb. I have a stock...