1moretoy's latest activity
-
1moretoy replied to the thread Engine Bay Down Bars.Both bars are in. Just need to make a bracket to tie in the inner fender. -
-
1moretoy replied to the thread Engine Bay Down Bars.I got the passenger side bar 80% welded in. I will do the same for the driver side. Once I get the motor out, I will weld the rest of it...
-
-
1moretoy replied to the thread Engine Bay Down Bars.Yeah, I don't have a cage so the firewall is my only option.
-
1moretoy replied to the thread Engine Bay Down Bars.Well I got both bars cut and ready to weld. I'm going to weld 3/16 plate to the firewall and then weld the bar to the plate. So far I'm...
-
-
1moretoy replied to the thread Engine Bay Down Bars.Ok, I decided to go ahead and do the bars. I see some added an extra plate to the firewall and some don't. What is the general idea...
-
1moretoy replied to the thread Tilt Steering Column.I purchased a universal tilt from ididit because I didn't want the key in the ignition as I'm going push button start. I removed the...
-
-
1moretoy replied to the thread US Cartool Braces.Thanks all, I ended up mounting the wheels on the car just to be safe. I had to disassemble the brakes so they would clear but this is...
-
-
1moretoy replied to the thread US Cartool Braces.Is it ok to weld the US Cartool kit on with the car on jacks or should it be on the ground?
-
1moretoy replied to the thread Santa Came Early!!! Hellcat Redeye build with RMS suspension!!!.It's been a while since I posted. Made lots of progress the last couple of months. I got the front brakes done, rear end is complete...
-
-
Hey all, quick question on a steering column. I know Flaming River and ididit both make columns for the e-body but they are very...
-
-
1moretoy replied to the thread Master Cylinder mounting.Yes. Hooks up to the factory pedal.
-
1moretoy replied to the thread Master Cylinder mounting.Yup, I'm going 18/19 wheel combo. I have a 9" with 35 spline axles, detroit trutrac and 3.00 gears.
-
1moretoy replied to the thread Master Cylinder mounting.Thanks for the offer Heminut, I actually found my plated today, woohoo. Thanks Xcudame, I purchased an adapter plate similar to the...
-
1moretoy replied to the thread Master Cylinder mounting.Yeah, I was thinking that too. I could always weld that area under the dash to the firewall as well.
-
1moretoy replied to the thread Master Cylinder mounting.Got it. I don't plan on running my wiring that way so I guess I can cut & weld them. Is there a good source for the plate and adapter...
