540HemiCuda's latest activity
-
5540HemiCuda replied to the thread What carb size mopar 340..I have bought a couple of dozen 3310s over the years at swap meets. Usually, less than a hundred bucks. But NEVER one new. But they were...
-
5540HemiCuda replied to the thread What carb size mopar 340..So much for civility. Thank you for exiting. Juvenile name calling does nothing to support your position or advance the discussion. .
-
5540HemiCuda replied to the thread What carb size mopar 340..I have Emanuel's Holley book. As well as the Walordy Holley book. And I think I still have an old Edelbrock tuning...
-
5540HemiCuda replied to the thread What carb size mopar 340..History lesson aside, you did not attempt to answer the basic questions I asked, so I will try once again: A)Why is the air valve ONLY...
-
5540HemiCuda replied to the thread What carb size mopar 340..What exactly was an insult? I corrected an obvious mistake and responded to being accused of using AI rather than my experience which I...
-
5540HemiCuda replied to the thread What carb size mopar 340..You do realize that the choke is manually controlled and often does not need to totally seal the venturies while the air door must be...
-
5540HemiCuda replied to the thread Looking for carb advise..Have you tried any of the Street Demons? Their triple stack boosters and polymer center sections are no joke. I prefer the 4150 style of...
-
5540HemiCuda replied to the thread What carb size mopar 340..So you're saying that the air door's resistance to air flow does not help pull fuel up and out the boosters as well as enrich the...
-
5540HemiCuda replied to the thread What carb size mopar 340..Another correction; I am not calling the AVS a mechanical secondary carb. They ARE a mechanical secondary carb. What other category...
-
5540HemiCuda replied to the thread What carb size mopar 340..I don't know what parts manual you are using, but it is INCORRECT. And I am not going by anything other than 55+ years of personal...
-
5540HemiCuda replied to the thread What carb size mopar 340..With a 4 speed and 3.55s, you don't need vacuum secondaries. Remember that originally most of Mopar's performance engines got mechanical...
-
5540HemiCuda replied to the thread Looking for carb advise..The best out of the box carb I have found is the Street Demon. Very similar to the old Thermoquad in design with both bolt patterns to...
-
5540HemiCuda replied to the thread rear height.I don't know, never tried it. Nor have I seen leafs removed to lower a car. I can tell you that using shackles to lift the rear was...
-
5540HemiCuda replied to the thread 440 crank into a 400 block question.Here is some good information on this subject. The thread is old and the part numbers and sources may have changed, but the information...
-
5540HemiCuda replied to the thread rear height.Keep in mind that when changing the front spring perch height that you are also changing the pinion angle. Chrysler spent a lot of time...