Recent content by 69bbb7gts

Welcome, love the white interior

I have built many motors with hyper pistons for street cars with no problem, you have to go bigger on the top ring for sure going a Little bigger than recommended is not a problem either. I use them because they seem to have better selection for Street builds. Other than that you have to buy a...

Once you know the block deck height, you compare the compression height of the piston to see where it is going to be in the hole

When deciding on the Piston you have to know the block deck heights. You have to know where the Piston is going to be in the hole so you have to figure out half the crank stroke, the rod length and the compression height of the piston. That will tell you where the Piston is going to sit in the...

You can take a flexible tape measure and go 2" from the tdc mark will be approximately 33 degrees on a standard Mopar balancer

Did you see the pictures of the left hand studs?

They look original to me. Just the stamping is not done that well

70-71 2 piece rotors measuring .990 and .940, left and right hand studs comes with inner bearings and seals and outer cones, clean front and back, $525 plus shipping

Unrestored 'Cuda fog lamp. 1 only, make offer Mike 585 330 1618