Recent content by 72 340 4spd AC

Hey, thanks a ton! I ordered the Moogs Apparently Rockauto site is incorrect, consequently I have a set of K7309's if anyone wants them.

I think you need the part in pic on post 14 called "self adjusting clip". It hooks onto the cable then slides onto the pin on the water valve. It's not really self adjusting though.

Looking for the part number for the rear shackle bushings that go into the P4452984 / 5 leaf springs. The Moog K7309 is to small ID inside the spring. Thanks in advance for any help!

Set of big block engine mount brackets Located in South Jersey $50 + shipping

Thank you all.

Joined a little while ago and finally got it out of enclosed trailer it's been sitting in since 1994! bought it in 1978 for $2250, daily drove it for about 2 years until I thought it broke a piston ring as it was puffing out the oil fill like a train. It sat till 1993 when I found out it just...

Check this AAR out

How did you reseal it? What did you use?

I have that problem also. Happened on 2 ECU boxes I have. One sat on a shelf for years and all the sudden it started running out. Other on one was on my 'cuda 40 years and about 3 years ago it started running out. No idea why. When I saw Mr Cuda post I was hoping someone had replied.

I had the same sort of problem. Turned out the head gasket was blown at the top of one cylinder and all the compression was going into the lifter valley.

Thank you I'll check him out.

I have a '72 'Cuda 340 4 speed with factory A/C and I need a white vinyl top installed. 2 questions, where is the best place to buy one and can anyone recommend a shop in the South Jersey area to install it? Thanks

Funny, I had a '72 Challenger and I put a '70 grille in it. I really liked the look!