• Welcome to For E Bodies Only !

    We are a community of Plymouth Cuda and Dodge Challenger owners. Join now! Its Free!

Recent content by 73Banana

  1. 7

    Ground locations 73 Challenger A/T

    Hi Xcudame: when you get a chance send over that picture you mentioned above? Thank you
  2. 7

    Ground locations 73 Challenger A/T

    Hello, i have the laminated wiring diagram for my car. I found the ground for the headlight, side markers, etc. Am searching for the ground for the rear lights, rear side marker, etc. No luck, are there any diagrams/photos/shop manuals that physically show where all the grounds are for the car...
  3. 7

    Shifter lamp again #2 ask

  4. 7

    Shifter lamp

    I am no expert(especially auto electric)however, your right, i installed an LED for the top left that shines on the control panel and it burned out as soon as i installed. Thanks Challenger RTA
  5. 7

    Shifter lamp

    Thanks Katfish, ill do that.
  6. 7

    Ground location rear lights

    Hi all, can someone please send a photo location of the rear lights, back-ups, etc. ground wire attached to body? I did find the front lights location. Thank you
  7. 7

    Spring under console linkage

    thanks they are
  8. 7

    Spring under console linkage

    Thanks Finoke, very helpful, just curious exactly what purpose does it serve?
  9. 7

    904 tranny at

    Hi, do you sell rebuilt transmissions?
  10. 7

    904 tranny at

    Thank you Xcudame, forever grateful for you and this forum.
  11. 7

    904 tranny at

    Good question Katfish. No wonder I did not find this metal dampener in service manuals.
  12. 7

    904 tranny at

    Thanks, another issue is back a few months I reversed the car and while rolling back at about 7 mph I threw it into drive. I drove it home(10 miles)and on a hill going down or up from a dead stop sign it made knocking/grinding noises. Is the loose dampener and the above related? Or 2 separate...
  13. 7

    904 tranny at

    Thanks all, i may get under the car tomorrow for pics
  14. 7

    Edelbrock Carb Help Please

    Thank you MP, will check this out on my manual.
  15. 7

    Edelbrock Carb Help Please

    What would a "stumble" mean? How can i tell if the accelerator pump is on slow feed? The engine is a 360.
Back
Top