• Welcome to For E Bodies Only !

    We are a community of Plymouth Cuda and Dodge Challenger owners. Join now! Its Free!

7DCUDA383A's latest activity

  • 7DCUDA383A
    7DCUDA383A replied to the thread Preload the carb.
    So where my finger is correct , how much in each I have a syringe for this , where is the accelerator pump .
  • 7DCUDA383A
    7DCUDA383A posted the thread Preload the carb in Fuel and Air Systems.
    Almost ready to fire this thing up , is it wise to fill these up with fuel before cranking the engine , and how much on each side .
    • 20250502_132127.jpg
  • 7DCUDA383A
    7DCUDA383A reacted to gzig5's post in the thread Value cover studs with
    Like
    Like
    .
    Rule of thumb is that the length of a threaded fastener going into the hole should be at least the diameter or the thread. Going longer...
  • 7DCUDA383A
    7DCUDA383A replied to the thread fuel adapter.
    • 1746193614791.png
  • 7DCUDA383A
    7DCUDA383A replied to the thread fuel adapter.
    I am putting a heat shield sleeve over it , I know its not proper but I really dont feel like changing the pump right now , next winter...
  • 7DCUDA383A
    7DCUDA383A replied to the thread fuel adapter.
    Me too and will do , thanks again .
  • 7DCUDA383A
    7DCUDA383A replied to the thread fuel adapter.
    I was looking for a rubber 90 degree or something like that , I'm just gonna run it up to a filter and go , it isn't that bad of a bend...
  • 7DCUDA383A
    7DCUDA383A replied to the thread Value cover studs.
    I didn't think about the double nut but they are in all the way and no loctite , it's seems good but you never know with these cars ...
  • 7DCUDA383A
    7DCUDA383A replied to the thread Value cover studs.
    It just didn't see long enough in the head part , the only issue I had were the 2 lower holes had too much of an angle so I used regular...
  • 7DCUDA383A
    7DCUDA383A reacted to Xcudame's post in the thread Value cover studs with
    Like
    Like
    .
    See factory specs below. Looks like just 5/16" goes in the head. So you're good with what you have!
  • 7DCUDA383A
    7DCUDA383A posted the thread Value cover studs in Engine Issues.
    Have these ARP 200-7620 studs , is that it all needs to go into the head , looks short , also have MP valve covers , any loctite.
    • 20250430_163551.jpg
  • 7DCUDA383A
    7DCUDA383A reacted to Shaker71's post in the thread Distributor length with
    Like
    Like
    .
    There’s one listed on Moparts in the E-body for sale section. $75
  • 7DCUDA383A
    7DCUDA383A replied to the thread fuel adapter.
    The Carter 3672 should be good for my 383 then .
  • 7DCUDA383A
    7DCUDA383A replied to the thread fuel adapter.
    I have heard about those but does the psi matter , I think the one I have is 6 psi and the others at 8 psi , if I'm wrong let me know ...
  • 7DCUDA383A
    7DCUDA383A reacted to pschlosser's post in the thread Hand cranking the engine with
    Like
    Like
    .
    While you can manually prime the engine using the correct shaft on the distributor drive, if the engine has not been freshly rebuilt, I...
Show older items
Back
Top