Recent content by BrownChallenger

Part 3: Pedals and Hydraulics I copied a lot of my pedal/hydraulic setup from 'No Bolts Left Behind' on YouTube. Link here to what he did: I used the same pedal and MC, below: Wilwood 340-13834 Pedal Wilwood 260-13621 Compact Remote MC (Bore size is important to get proper throw) If you have...

Yes, I have been working on a shifter linkage to fit under the E-body console and a custom speedometer driver similar to a Speedbox. I can also post some driving videos and finish discussing the hydraulics soon.

Is anyone interested in an electronic to mechanical speedometer drive unit that doesn't cost $450 like a Speedbox?

Part 2: Working Rearwards... ------------------------------------------------------ Pilot Bearing: I used this Holley swap pilot bearing after looking through a lot of stock options, looking at sizes of bearings for both 5.9 magnums and Colorados on Rockauto, and measuring my trans and crank. It...

I just added up all my purchases and I'm right around $2k. This includes everything between the pilot bearing and rear u-joint, clutch pedal, hydraulics, gear oil, and a smaller Hemi style brake booster at a whopping $300. This does not include a shifter setup or electronic speedometer adapter...

Looks pretty close! I once saw an Autumn Bronze Metallic car that looked like mine, not sure of the code.

TLDR Parts List: ~05-07 Chevy Colorado/GMC Canyon/Isuzu Truck AR5 5 Speed Manual RWD 90s Dakota Bellhousing 3.9L V6 5.9 Magnum 143T flywheel (differs depending on engine balance) ARP Flywheel Bolts McLeod Performance Clutch ARP Pressure Plate Bolts Holley Adapter Pilot Bearing Colorado Stock...

I was in your exact situation, Gary, that's why I wanted to share this build. I will try to get a "first installment" posted this week.

Hi all, my first real post here. Would anyone be interested in a writeup on my AR5 5-speed transmission swap into my 1971 Challenger? It is similar to the AX15 swaps I've seen on here but capable of more power (at least 400). I did not need to remove my t-bar crossmember like the 6 speed swaps...

PM sent

I purchased this item but did not realize it is 3" diameter. I have 2.5" exhaust so I am looking to sell it.

pm sent

I have two of the rear mufflers/resonators (pipes cut right near them) if you happen to still need them