• Welcome to For E Bodies Only !

    We are a community of Plymouth Cuda and Dodge Challenger owners. Join now! Its Free!

Recent content by casper

  1. casper

    Timing mark almost 180° off?

    So you say it runs fine. After checking the key on the balancer and that is fine. I would tune the timing by rpm , turn the engine to point of ignition on #1 cylinder, and put a mark on the timing cover and the harmonic balancer then that would be my timing mark at idle for future tuning and...
  2. casper

    To be A/C or not to be A/C

    Just food for thought. Not all 73 challengers did not come with a/c. So one with original ac is more interesting.
  3. casper

    Terrible ride quality - rear end clunks and bangs

    All sounds like good advice. I would start by checking for lose bolts and parts. Not to forget to look at the wheel lugs. Could be that simple. Don't buy till you narrow it down to an specific part or two.
  4. casper

    High Charging Voltage

    Did that . I growned it directly to the block. No change
  5. casper

    High Charging Voltage

    I'm having ,some what the same issue. Mine is at 17volts. I replaced the voltage regulator. No change. I suggest that you have your alternator tested to eliminate it from the equation. After that test the votage to it, the wite to the vr and proceed back. Mine has 10.5v. Going to the...
  6. casper

    Are My Oil Pressure Readings Normal

    I also believe it is fine as long as you used a stock oil pump. If u put in a high volume pump than it is on the low side
  7. casper

    hello

    This is my first time joining a form. Im not sure what to expect but i do like reading about peoples problems and fixes. I have a 73 challenger that i have built, with some help, from the ground up. Hope to post a picture soon.
Back
Top