Recent content by CCKen

Yes the factory shroud is P/N 2785435. It is considered a 26" radiator by Chrysler. They go by the outside measurement.

Juan, What part is the radiator? I may be able to get you a part number for the factory shroud.

You do not need to go to a high flow water pump if you go from a downflow to a crossflow radiator. You can use the integral trans cooler. You could run the 26 inch or 28 inch downflow radiator to make the replacement easier.

What part number radiator do you have? What is the shroud part number?

Take a look at Cold Case Radiators. You can use the factory shrouds on the radiators. Two row 1-1/4" tubes

We recommend a glycol based green 50/50 mix

Have you checked to see if the heater core is blocked. Sometimes that is an issue.

What temp thermostat are you running?

Visit Cold Case Radiators website. www.coldcaseradiators.com 2 core Aluminum radiators with 1-1/4" tubes

What thermostat are you running?

Sounds like a good option. Good luck.

Our has an outer flange that the shroud mounts to. We use the slide in feet as well.

Our shrouds mount to the radiator with pop rivets or self tapping screws.

Looking at your photo. There is enough room to drill holes and use a bolt nut and lock washer to mount them.

At Cold Case our shrouds have nutserts in the shroud to mount the fans. The legs slide into the grooves on the fan to mount to the shroud.