Recent content by chrisperanio

pulling the steering column is easy and its the only way i could get my header to go in on that side. one roll pin 4 bolts and 3 plugs.

Parts for sale located in Queenstown, MD. I prefer to be contacted by phone 4104908648 440 heads stock used casting is 4006452 $175 pro-form carb 850cfm mechanical secondaries used $400 Edelbrock 440 torkar 2 (has been ported) used $200 Holley high flow fuel pump with push rod 110gph @ 6.5...

I agree everything has to be built and set up properly, but thats with any engine.

I love mine track or street. Loads up a bit when sitting so on the street i lean her out a hair and turn up the idle a tad and pow no issue...but my set up is a bit different then yours I'm running .610 lift cam, 5000 nitro stall, ported and polished everything with the biggest valves i could...

Getting ready to measure and cut a hole in my hood for my tunnel ram set up. Anyone out there with experience/have done before, please explain the steps you took measuring everything out clearance...how much extra room should i give the hole for clearance around parts...and anything else you can...

gerstsuspensions.com best suspension kit on the market

gerstsuspentions.com need i say more

Thx

That's not what I asked. Please don't comment unless you are going to give me the appropriate answer. Purchasing a spring location kit is not going to assist me with tire clearance. #mycarilldowhatilike

Does anyone know if 325 50 r15 will fit on the back of a 72 cuda. I have a set of 3 inch higher leaf springs on the back

Does anyone know if 325 50 r15 will fit on the back of a 72 cuda. I have a set of 3 inch higher leaf springs on the back

Army, 82nd Airborne, Ssg, 2002-2014, 3 tours in Iraq and 1 in afgan.

i have a 75 440 block in my race car i had drained the water out from the radiator before winter like i do every year this year i guess it did not completly drain and a freeze plug popped out on the passenger side front.....what are the chances that the block is damaged and how or what is the...

thx for recommending hughes they have what i need

i tried edelbrock they do not make a plate for performer heads