Recent content by DeMopuar

I'd like five of these - please get in touch when you have time. Shipping to Wisconsin.........USA.......

PM Sent

How much for the rear frame rail tie downs? I've got them circled in red. Shipping would be to lower 48......

O.K. I was looking for mint originals -- thanks for getting back on this. I'll keep looking for originals........

Can you show closeups of the back side of the two pieces circled in red?

Looking for a dry clean original sheet metal 1970 Cuda coupe. No basket cases. No repaired sheet metal. Original paint cars most desired so I know exactly what I'm buying. Looking for entire car with front and rear clip -- but if all there is the basic unibody I would consider it - but it...

I'm interested in hearing the restoration of this T/A but your inbox is full. You can also email me at mhoffman at hoffcons dot com . I'm very interested to hear what has been done to the sheet metal as far as repairs or replacement. This looks like a great car. Hope to hear from you...

Looking for a 294 stamped small block oil pan if you'd have one.

Looking to buy a nice "294" small block mopar oil pan for my 1971 Cuda. Needs to have a decent bottom that isn't all dented up. Also, the 294 numbers need to be clear and not rubbed off from scraping on the ground/cement floor. PM me here or email at mhoffman at hoffcons.com . Thanks, Mark

Thanks FEBO - Found One!!!!!!!!!!!! Thanks!!!!

O.K. Too early for my car unfortunately. Thanks for looking!!!!!!

Looking for a nice rust pit free barrel 1077 wiper motor between 0980 and 2380 for the date code. Thanks!!!

Linkage, crank, switch - all different.

Thank you for that lead................