Recent content by Flathead31coupe

Thanks....

Since there are 6 of them, do you think one goes on each side?\nOf the rubber thanks

Thanks everyone when I get further along on putting it together.I'll be able to check these things out....

They look like they would go inside of a rubber piece of some sort.There are tiny..

Since I have these I may go ahead and just drill the hose and use screws for mounting.

I see thanks

Thanks. So the square holes in my cowl are for the snap in grills

Little confused. I have a set of cowl vent grills that came with the car.. There are holes around the outside of the grills that looked like they should be screwed into the cowl but there are no holes in the cowl... Unless the proper grills have some type of mounting them.. There are square...

Any clue what these could be... I assume they go inside some kind of rubber grommet not sure where thanks

Yes ,and two washers I can get a bolt that size just about anywhere...but looking for oem

The bottom picture has the bolt that I'm looking for that.Goes through into the nut that's welded to the bracket

Looking for a factory three forty engine mount bolt the long one.. I'm also looking for two u bolts and nuts for a 8-3/4 thanks

Thanks

Looking for a factory Ignition control, mounting bracket that mounts to the firewall and bolts.Thanks