Recent content by hemi71x

These are pair of Disc Brake hubs, and all 10 of the wheel studs, for the two piece rotors, (rotors and hubs) that are used on the 1970-72 B & E body line of cars. 4 1/2" inch bolt pattern. All the studs are RIGHT HAND thread. Selling at $150.00 for everything, plus $24.75 for the mailman in...

From my transmission rebuilding days, found out that i have this new old stock, transmission band used in the 426 Hemi Torqueflite automatic transmissions. It's a Raybestos manufactured band. I'll sell it for $325.00 bucks, plus whatever the mailman is going to want to your zip code. Payment, i...

MoparCarGuy Thank's for posting that information. The guy that i sold it to, must have had that report done on the car. Found out on the internet this morning that at the Mecum auction, back in 2020, it was owned by a dentist, back in Pennsylvania. I'm going to see, find out, if he's still the...

YES, i know this is the "E" Bodies site, but please forgive me for asking this question here on this site, also. It's important for me to find out. Would anyone out there in the Mopar world, know where the Purple, 1971 Hemi GTX 4 Speed car, in now located, and possibly who the owner is? It's had...

This is a rear window defogger blower motor, and bezel, used in the A, B, E, body line of cars. Selling at $90.00 for both of these parts. I figure shipping will be $24.75 in a USPS, large, flat rate box. Payment i accept Pay Pal, or a USPS money order. Thank's a lot. Jim V. hemi71x

That's correct. Depended on the rear end gear ratio.

Contact seller Putting this FEDERAL power steering pump up for sale, that literally have been hanging on the garage wall for decades. If you don't know the difference between pumps, please look at the last picture in my ad. 1. FEDERAL pump. Bare unit, no pulley or bracket(s) for this one. Has...

Contact seller Well, guess i collected, saved, power steering pump mounting brackets from back in the 70's when cars were find able, to be picked over, at the U-Pull-It wrecking yards out here in California. Ok, here's what i have. 1. PS pump mounting brackets for the old Poly 318 engines with...

I have this two speed windshield wiper switch, that my research tells me it's for the 1972 and up, E body line of cars. Rallye gauge instrument panel, and non rallye gauge panel. #3488773, stamped on the switch. I'll be comfortable in selling this switch, letting it go, for $40.00. Prices for...

I also have these Pin Type, and Slider Type, caliper mounts for sale, that are for the standard 10 3/4" inch brake rotors. To go with the single piston calipers that i also have for sale, if you need them. All cleaned up, soaked out in a pail of Evaporust, then painted up. Ready to bolt on...

I have this power steering pump, mounting bracket for the FEDERAL pump, that is used on the Mopar big block engines. Officially i think it was used from the 1969 to 1972 years, but use it on any Federal pump that you want to, and any year engine that your using. I cleaned it up, soaked it out...

Contact seller I'v got four of these chrome, remote control, left door, drivers side, "Rallye" style mirrors up for sale. They literally have been in my closets for decades, and long...

I have these disc brake spindles, that i am putting up for sale. Please read this ad thoroughly and understand it. Both of these spindles are for the LEFT Side, DRIVERS Side of the car. The spindle pictured on the RIGHT, is used on the 1970-72 B & E body line of cars. It has a smaller diameter...

I have a few sets of radio knobs from the 71-74 B body line of cars, and the 1971-74 E Body cars, Barracuda's and Challanger's that i am listing, for sale. Selling at $20.00 for each set, which gets you the two inner knobs, and the two outer knobs. Payment, i accept Pay Pal. Will need a few...

I have these two 1970 E Body, Cuda & Challenger shifter knobs up for sale. $30.00 each, plus a few bucks for the mailman, to your zip code. Payment, i accept Pay Pal. Thank's for looking. Jim V. hemi71x EDIT: One of them has been SOLD.