Recent content by Ls1slow

$1200 (OBO) agin restored ready to go

@gran coupe john your inbox is full. I’ll look into shipping cost later today. Any specific shipping company you prefer to use.

Lincoln Nebraska.

I have an original 71 Cuda passenger side head light bracket for the buckets with the short and long bracket. The side that mounts to the fender is rusty but it’s not seen once installed the area that is seen is super clean and good shape. Look at pictures for condition and can provide more if...

I have a original gilled 71 Cuda fender not cut in gills for the passenger side. It’s has some pitting on it but looks good once you put filler back on it. They are getting hard to find anymore. It’s located in Lincoln Nebraska. I’m willing to deal with shipping it. Just don’t know what the...

I have an already restored 8550 booster that’s for a 1970 or early 1971 cars. Plus with the correct original linkage and spring. Look at pictures for condition does have some slight pitting on it that wont be noticeable once installed. Asking $1300 (OBO) for it plus shipping Parts located in...

I don’t know how hard these are to find but I’m looking for an original clutch pedal to Z bar rod in good condition and not bent. I think all 70-74 E body’s and 71-74 B body’s are the same. I know they make reproductions of this but for my build I’m looking for original. PM me on here.

I have a barely used K&N air filter for a 69-71 340-440 six pack and hemi cars. It has a lifetime warranty on it. I’m asking $100 for it (OBO) plus shipping. Part is located in Nebraska for pickup if that works for anyone.

I’m not a body guy and that’s why I got burnt on this should’ve stuck with my gut and knew the guy was hiding stuff because when I bought it it was all filled in and looked great. My body guy who stripped it down doesn’t think any damage just salt water corrosion I can post any pics anyone...

Any interest around $500.

I have an original 71 Cuda gilled fender passenger side it’s a little rough but these are getting hard to find in any condition. It’s located in Nebraska I’m willing to deal with shipping it I just don’t know what the cost would be Asking 800 (OBO)

I have a used reproduction front license plate bracket. It was bent a little so plate would sit level in front of car. Could easily be bent back or to how you need it to fit your car. It fits 68-69 Chargers and 70-72 CUDAs Otherwise in good condition. I would prefer not to scrap it. Asking $10...

I have an original front license plate bracket with part number stamped in it. There’s no rust pits in it. It’s been a little bent at some point to fit better to the bumper. It can easily be bent back straight or to how you need it to fit. Fits 68-69 chargers and 70-72 CUDAs. I’m asking $40...

Offers?

I have the vertical and horizontal hood latch support brackets. It’s still in the original paint and not bent at all and no rust. It’s in great shape. Fits 70-74 E body’s and 71-72 B body’s. I’m asking $80 plus shipping. The repo cost $50 just for the vertical and this is orginal stamping...