Recent content by mopinaround

On previous cars I have always folded the carpet over the pinch weld and then installed the sill plate. However, I just installed mass backed carpet in my Challenger and it was too thick to install the sill plate with it folder over. So I cut it even with the top of the pinch weld and it worked...

If using jack stands, get the HD 3 ton ones. They are much more stable. I just did a 4 speed swap and TTI exhaust on HF 3 ton stands. I also made some wheel cribs for installing my frame connectors. They work great also. Be safe!

71 Challenger small block kickdown linkage, $75 + shipping. Mishawaka, IN.

TCI Streetfighter 727 smallblock tranny. 10" 2500 stall converter balanced for 360 magnum, aluminum deep pan, transmission cooler, tranny lines, Amsoil synthetic fluid. Less than 1,000 street miles, works great. $1700 new, will sell all for $1000. Mishawaka, IN.

73 340 Exhaust Manifold, right side, p/n 3418623, casting date 7-27-72, $75. Mishawaka, Indiana

440 Sources billet flywheels are very nice and good price.

I'm looking for a 72-74 3-speed wiper drive link p/n 3431102. Found one, Thanks.

Sold the car with them on it.

Mishawaka, Indiana

Selling the 6 Pack with the car

Price reduced to $1800.

I know the p/ns are there. Don't know about the date code. I might separate them.

Just the Promax plates and the air cleaner cost me over $600. I'm selling the swinger and don't think these will really add to the value of it. Thought maybe someone doing a TA or AAR resto might be interested. I can get the p/n's if needed. Thanks

70 340 Six Pack Setup, original factory carbs and intake. Completely rebuilt. Has Promax jettable metering plates in the outboard carbs and Promax base plate in rear carb. Currently on my 69 swinger 340. Runs awesome. Comes with air cleaner assy, 2 sets steel fuel lines, jet kit, extra power...