Recent content by mr340

4-hole is power, 6-hole is manual

I know this is an old thread but here goes. What is the difference btwn the manual and power reinf. plate? I'm going from power to manual. Can the power plate be modded to work with the manual master? thanks, Gary Got the answer on another forum. yes they are dif. center hole is larger on the...

for hole location check the att. pic. the cable is not installed in this pic. that cable with the red wire going thru the grommet is the speedo cable. the A/C cable goes thru the hole that is blocked with the black bumper to the left and a bit above the speedo. Hope this helps.

this is the best I have. it runs across the eng. comp right in front of the cowl.

I ran the Crane Golds on my 340 for over 10 years with no problems but some have had issues with the adjusting screws failing. When I built my 416 I went with the Indy roller rockers and they have been holding up well.

here's the pieces to hold the hood up. you two, one for each hinge.

Jaun, thanks for the comments:occasion14: Awnsers:The black behind the bumper @ the fender is paint. originally there was a black plastic filler there. the car had been repainted and when I remove the filler the paint there did not match the rest of the fender other wise I would have left it...

another view

I used '70/71 brackets on the front. it allowed me to remove the 20lb brace in the front bumper. I reused the bumper, just put an exttra blot in the unused hole.

:thumbsup:Looks Good!

btw is only "by the way" if you use caps............;) you forgot ROFLMAO rolling on floor laughing my ass off

Walt, btw=between, I just didn't feel like typing the whole word. I pretty much agree with what burdar said but if you don't want to move the bumper in I would paint the fillers flat black As for the grille, leave the stainless piece around the grille silver and the leading edge of the grill...

When painting the grill black I would also black out the filler pieces btw the grill and bumper and btw the bumper and fender too.