pschlosser's latest activity
-
I think we have a winner. Took the car out to fill the tank, uneventful so I thought I would take the long way home and enjoy the cooler... -
pschlosser replied to the thread 1971 Barracuda door mirror location.You can buy the rivet nut tool (for reproduction doors without the holes or nut) from many sources, even HF.
-
pschlosser replied to the thread 1971 Barracuda door mirror location.
-
pschlosser replied to the thread SOLD Go Wing.Can you tell us what that wing assembly weighs as pictured?
-
pschlosser replied to the thread Fender fore and aft alignment.How much are you looking to move it? And why? I mean, what other point of alignment reference are you shooting for? For a factory...
-
pschlosser replied to the thread Thermoquad Rebuild Kit.In many cases, it's the disassembly, cleaning and bench adjusting that does the majority of improvement. Over the years, and in a...
-
pschlosser replied to the thread Help! Trunk latch question.The dealer parts book lists differing latches for the barracuda and challenger. challenger is shared with other models. The barracuda...
-
pschlosser replied to the thread Help! Trunk latch question.Uncertain. Are you expecting a "genuine barracuda trunk latch" to be sild with the rod? Compare to a door latch or door handle, I...
-
pschlosser replied to the thread Help! Trunk latch question.The rod indeed activates the lock mechanism by the keylock. So you'll have to source the rod, as well. And I don't see those latches...
-
pschlosser replied to the thread Thermoquad Rebuild Kit.I vote they are the same. While I don't think it an absolute, the hearsay among the old guys in the know, is Carter carburetors stamped...
-
pschlosser replied to the thread Thermoquad Rebuild Kit.You may not have many options for a rebuild kit. I have purchased more than one to get the job done. And if I find a vintage kit...
-
pschlosser replied to the thread What carb size mopar 340..I agree. If you're calling the AVS a mechanical secondary, then you are indeed correct. Now I'm not sure what that whole "air valve"...
-
Below are the before and after pics of my emblem. I spent about $10 for supplies and by buddy did it up for me. Turned out pretty good...
-
pschlosser replied to the thread Dash dimmer switch question.when this is all through, if you're throwing it away, I'd like to take a crack at it. :p
-
pschlosser replied to the thread Shifter lamp.the majority of LED bulbs are configured for the center pin to be POS and the shell to be NEG. In most cases, this is not a problem...