Recent content by QuickBpBp

I understand that BUT they were 440 E-bodies in 1970...

According to Scott Smith the Carb guru HE has seen them on 1970 models also.. So not on an E-body? I will check into that. I am a B-body guy... Fuel - Misc Parts - 70-71 Mopar B E Body Cuda 440 AVS New Delco Remy Idle Solenoid DR1114447 - 70-71, Mopar, B, E, Body, Cuda, 440, AVS, New, Delco...

Nos 1970-71 440 Carburetor solenoid and bracket. It is part number DR1114447 with bracket and wire. Correct for B and E bodies. This was removed a long time ago from an nos carb. It does have some light oxidation. It would be excellent for a survivor type car as is or a very nice restored driven...

Beautiful original 72-74 Cuda stainless tail light rings. Both very nice with no dents and a nice shine. $20 each plus shipping Parts are located in SE PA. Can send more pictures if interested. Pm here on the board. Thanks for free ad FEBO!

Nos 1970-71 Cuda red rear marker lamp lens. Part number 3403638 and in excellent condition right out of the box. $75 shipped Parts are located in SE PA. Can send more pictures if interested. Pm here on the board. Thanks for free ad FEBO!

Good used Rally dash 4 bulb light bar. Wiring end is cut but will splice easy. One lens has a missing piece by the rivet. Will detail nice just soak in evaporust or glass bead. These are getting very hard to find these days. $250 shipped Parts are located in SE PA. Can send more pictures if...

Looks like it says on the receipt it's for a 512 inch??

You are welcome. I was looking when you posted you found it already..

Jamie at Mega Parts sells them.. Probably a few other places too. Pardon Our Interruption...

Here you can see the spring at the top of the gear shift control shaft.. Hope that helps.

The Overhead lamp with-out the lens is SOLD.

No door belt moldings for sale. I sold the one door belt molding I had to a member here a few weeks ago...

These are being sold quickly.. Still have a few left.

Unfortunately, I don't have the part number for them... I just matched them up with the ones in the trim I had over the years. I sold all the other clips I had in the ad below.. FOR SALE - 1970-71 Challenger Quarter Panel Belt Moldings & Belt Molding clips

I found a box of nos clips from a body shop that did the bodywork for Chrysler back in the day. Members on here confirmed the metal clips and nuts are correct for the 70-74 Cuda door belt moldings. The other clips appear to be the same ones used on vinyl top trim and possibly the door belt trim...