Ronbo73's latest activity
-
The stage is set! The three of you need to be there when their filming. Xcudame make sure Kitten is there too! Photo bomb all the scenes... -
It wasn't very hard to "badger" Heminut into uncapping his headers and entering the contest! His Cuda definitely had the best baritone...
-
Afterwards we went to a local watering hole for a late lunch and then I took Xcudame and his son by my friend's gas station where they...
-
It was just luck that the car show was taking place when Xcudame was visiting, I didn't even know about it until a couple of days...
-
So yesterday my son and I hopped into his 2015 Challenger Scat Pack and drove 171 miles through the Southwest desert to visit Heminut...
-
Ronbo73 replied to the thread 73 barracuda rear wiring harness routing question..The wiring runs along the driver side rocker panel behind the flexible wire guards that are under the carpet. Then up and over the...
-
-
Ronbo73 replied to the thread Kelsey Hayes Proportioning Valve Stock?.It's what my 73 has. I had mine rebuilt because I could not find one anywhere that didn't need to be rebuilt.
-
Ronbo73 replied to the thread Hello from Maryland.Welcome from Massachusetts! All very nice vehicles. I like the wagon with the air deflectors to keep the back window clear, I presume?
-
Ronbo73 replied to the thread Hello from Montana.Welcome from Massachusetts! Good looking Challenger. Check this website out for wiring. Evans Wiring - Home
-
Ronbo73 replied to the thread Not 'Factory' installed Things found on your Mopar -.Your friends may have been a "Chapman" alarm system. If you google Chapman alarms that exact alarm system shows up.
-
Ronbo73 replied to the thread cooling combo questions ….I used Mattson's custom radiator for my custom electric cooling fans. For some reason their website is down. Here are a few links...
-
Ronbo73 replied to the thread Steering column bearing.Is that the end of the steering column that's in the engine compartment? If so, this what mine looked like before I replaced the old part.
-
-
Ronbo73 replied to the thread Not 'Factory' installed Things found on your Mopar -.I don't have a picture but my car had the 80's "Chapman Lock" anti theft system installed. The locking part was under hood that slid...
-
-
Ronbo73 replied to the thread Steering column bearing.My 73 did not have any bearing at the end just a foam seal to help keep dust dirt and wind from coming up into the column. The steering...
