Ronbo73's latest activity
-
Ronbo73 replied to the thread 73 Cuda fuel sender return port.You can run a hose from the second (open) port on your sending unit to the line that runs where the charcoal canister used to be. Trim... -
Ronbo73 replied to the thread 73 Cuda fuel sender return port.The vent is the tube/port on the passengers side of the fuel tank. Pictures 2, 3 and 4 show the venting system. It is all contained in...
-
While there ARE fuel filters with a built-in third fitting that may be used as a return line, the majority of fuel filters have two...
-
Ronbo73 replied to the thread 73 Cuda fuel sender return port.pschlosser explains it all above.
-
Ronbo73 replied to the thread 73 Cuda fuel sender return port.I just want to be clear that there are many ways to do what you need. This is just my opinion. And you know what they say, "opinions are...
-
-
Ronbo73 replied to the thread 73 Cuda fuel sender return port.Since you are missing the charcoal canister and you are not going for a contours restoration, I would eliminate it all together. I...
-
Ronbo73 replied to the thread Sudden Lifter Noise.You might want to figure out why they are bending before you replace them and bend more. Maybe the wrong length push rods or if you have...
-
Ronbo73 replied to the thread Overhead console.The console will probably be ok with the two you are missing but you may be able to find some online. Those plates were used on door...
-
-
Ronbo73 replied to the thread Overhead console.Like pschlosser says, repair it. Looks like a fun project to handle. If you have the small steel attaching plates, I would use an...
-
Ronbo73 replied to the thread New Cuda Owner from Long Island NY.Welcome to the madness from Massachusetts! Nice 73!
-
Ronbo73 replied to the thread 73 barracuda front brake lines,?.This is how I installed them which I think is correct. I used pictures I took when disassembling my car.
-
-
Ronbo73 replied to the thread ‘73 Cuda grill.That sounds about right. The three on the bottom of the grille mount to the fenders and the hood latch support. On my 73 Barracuda, of...
-
Ronbo73 replied to the thread TTI system too long for Cuda.Yes, I had some clearance issues also. I found that the exhaust pieces were not as engaged into the each exhaust piece. I went back and...
-
Ronbo73 replied to the thread Hello from the great white north. Alberta canada..Very nice!
-
Ronbo73 replied to the thread TTI system too long for Cuda.Yes sir, looks nice and hanging straight. Don't snug the bolts through the rubber until you get the rest of your exhaust installed. I...
