Recent content by RYO5566

70 E-Body Quarter Window channel strip | Roseville Moparts Thanks for your reply. I would be happy if you could give me the passenger side rail. It's felt but I see they still have it for sale!

Hello! Thank you for your kind reply. The driver's seat was present, but the passenger seat was missing. I thought about making one myself, but the shape was complicated and I gave up. It seems that the internal rubber is still available as an aftermarket part. I would appreciate it if you have...

Hello! Thank you for the accurate advice! The inner rubber is sold as an aftermarket part, but only the outer guide is missing.

Hello! I'm looking for this part, but I can't seem to find it. The name of the part seems to be "rear run and retainer". This is a rail that supports the rear of the quarter window, but the parts for the passenger seat side were not included. Similar to the driver's seat, there is also a stay to...

Thank you for your kind advice! Are the photos showing the difference in height of the tail lamp panels? In my current work situation, the heights of the tail lamp panel and trunk lid panel, and the heights of the filler neck panel and trunk lid panel are symmetrically matched. In that...

Thank you for your kind advice! Dynacorn is also a high quality body panel! I was disappointed that I couldn't choose when I ordered the parts at Summit. As you advised, the Japanese expert who looked at the condition of my car also told me not to use the whole panel, just the corroded part...

thank you for the advice! The new gasket is made by AMD, but it is thick and causes the trunk lid to float. The old gasket has the same shape but is much thinner, probably because it has been crushed for many years. You need a gap between 1 dollar bills! Thank you for your kindness!

Thank you for the accurate advice! Since some parts are low in height, I thought it would be a great idea to cut a cut in the panel and jack it up from the bottom! Thank you for your help as I was very worried! In addition to AMD, there are body manufacturers such as Sherman, Good Mark, and...

thank you for the advice! Currently, the quarter panel and trunk gutter are fixed with screws, but the situation does not change even if you remove the trunk gutter and reattach the trunk lid panel, so I don't think the trunk gutter has any effect. The heights of the trunk gutter, deck filler...

thank you for the advice! All body panels, except the trunk lid panel, are made by AMD and have all been replaced. The front of the trunk lid panel is attached almost horizontally to the deck filler panel and the front of the quarter panel, and the rear of the quarter panel is attached...

thank you for the advice! When removing the body panels, I did not add reinforcements such as pipes, but I was careful not to apply stress while working.

thank you for the advice! The deck filler panel, trunk gutters, taillamp panel, trunk lock retainers, and trunkpan extension are secured with screws to match all lines. If you match the height of the rear of the trunk lid and the rear of the left quarter panel, the center of the quarter panel...

thank you for the advice! It would be reassuring to get advice from an expert! As mentioned in the previous person's reply, the parts related to the quarter panel (deck filler panel, trunk gutters, taillamp panel, trunk lock retainers, trunkpan extension, all made by AMD) are temporarily...

Hello! thank you for the advice! The current state of the car is that the deck filler panel, trunk gutters, taillamp panel, trunk lock retainers, and trunkpan extension attached to the quarter panel are fixed with screws. This photo shows the rear of the trunk lid and the taillamp panel lines...

Hello! I'm currently restoring a 70challenger. We are proceeding with the restoration mainly on the rear part, but I have a question for you all. As shown in the photo, there is an approximately 3/16 height difference between the left quarter panel and trunk lid panel. The quarter panel is...