Recent content by sedbld

I only have this one.

Sale pending

Sale pending

For sale is a Mopar starter heat shield. I’ve had this for many many years and IIRC it came off of a 383 truck that I parted years ago but should work on lots of different models. Especially if headers are involved. It’s in good solid condition just needs to be cleaned up and it is metal not...

Thank you for telling me! It did something weird when I posted it like computer reset and must’ve started me back a couple clicks. Thanks Mark

For sale is an original Mopar E body rally dash light bar. It’s in good condition just needs to be cleaned up and repainted. All of the lenses are intact and not cracked just a little warped. May have some pitting on the backside but not bad. Came off a 72 Barracuda that was parted years ago...

For sale is a Mopar starter heat shield. I’ve had this for many many years and IIRC it came off of a 383 truck that I parted years ago but should work on lots of different models. Especially if headers are involved. It’s in good solid condition just needs to be cleaned up and it is metal not...

Sale pending

For sale is a pair of original Mopar door lock key cylinder retainers for 70-74 E bodies. Also comes with the original screws. They are in great shape just need a good cleaning. Asking $35 shipped to you from 22630 or local pickup. PayPal,USPS MO, check or cash. Thank you FEBO!!

For sale is an original Mopar headlight bucket mounting bracket that came from a 72 Barracuda that was parted many years ago. It’s in great shape with only surface rust and needs to be cleaned up. Don’t remember if it’s a left or right or if they are both the same. Asking $30 OBO plus shipping...

Sale pending

For sale is a used Holley 750 dual feed electric choke carb stamped 80508-8. Was told that it had been rebuilt. I removed this from a 72 440 several years ago that started and idled but never was driven so it should be gone through again. Everything moves very nicely and comes with the dual feed...

Still for sale

Still for sale

For sale is a pair of used 3 1/2 x 3 inch header collectors with 3/8” flanges and approximately 6 1/2 inches tall. They were partially welded on one side of the exhaust pipes and were cut off when removed so they will need to be cleaned up or cut off just below the welding. The flanges are spot...