Recent content by STROKERCHALL

Agreed

I emailed and told who ever reads the emails about my experience, zero response so ya know the whole works of them are dicks

Well if you’re insinuating I was suggesting to this guy I knew more about their product you’re wrong. I never would’ve called if I “knew” everything

Thanks for your reply

Time to retire

Ya I will be looking elsewhere, I never would have called if my cam wasn’t from Hughes, others have said they ask for more preload. Knowing this I reached out to several experienced guys and mopar shops. As mentioned I was told one 1/2 turn to 1 full turn, this clown said 1.5 turns, the only one...

He might not have even given his name, probably didn’t being the ignorant pos he was.

Well I don’t have photos but i do have a good memory, he had me so pist off I forgot his name, A zero star review is coming and an email. Fk that A-ho!

The one full turn on the adjuster Duane suggested gives me 1 thread out

Thanks, I will never recommend Hughes after my phone call this morning!!! I will contact Smith Bros👍🍺

I posted early about my new valvetrain , push rods, rod measuring advice. To be safe I talked to a couple shops including Duane Porter who suggested his technique for establishing a proper push rod length and preload. To be sure (before I order push rods) I thought I would give hughes a call...

I bought this set off or amazon.ca. Terrible experience! They were supposed to arrive in 2-3 days, arrived in 10 with 2 updates the whole time, missing one big hold down and got an extra small one, one stud didn’t have a groove for a flat screwdriver to tighten. One hold down nut won’t thread...

Ya it’s too bad I didn’t see they won’t work on my future upgrade to the TF 240’s

The 440source aluminum roller tip and needle bearings is what’s on this engine. Plenty of scarring on the shaft and few flattened out needle bearings. I hope the prw 3244012 ones are better bc I am reading a few negative reviews with seized bearings and a gritty feeling, also a lot of...

Ok with rpm heads?