terrywalker's latest activity
-
Tterrywalker replied to the thread Clear Coat Paint.Back in the 60s when I was in high school, the old cars then, from the 1930 through the 1950s, for the most part, had a dull paint by...
-
Tterrywalker reacted to 1970Cuda360's post in the thread 1970 Dodge Challenger R/T Convertible Pilot Car with .This is such a sweet looking Challenger. Link: 1970 Dodge Challenger R/T Convertible Pilot Car
-
Tterrywalker replied to the thread 72 Challenger Fuel Tank Vent Size.All are 1/4". I suggest blowing out all four tank vent line tubes so they are clear. I ran a piece of wire in each one. There appears to...
-
Tterrywalker replied to the thread 72 Challenger Fuel Tank Vent Size.In my stock configured 72 Challenger, the four tank vent lines go into the tank liquid/vapor separator. The 1/4" line out of it goes to...
-
-
Tterrywalker replied to the thread heater box.Yes, it will work in other years non-A/C e-bodies. Here's what he's talking about non broken front cover. This is from my 71 Challenger...
-
-
Tterrywalker replied to the thread heater box.I just restored one where the front cover was broken like the OPs photos. I bought a new repro front housing cover to repair it. It fit...
-
Tterrywalker replied to the thread Tried to raise my son right...We all start somewhere. The first car I owned was a 36 Chevrolet Standard with inline 6. I worked on it and drove it. The next car I...
-
Tterrywalker replied to the thread Are kids fatter now?.I have driven both of my cars shown in Post #2 above across the country from coast to coast. The 71 convertible was comfortable for the...
-
Tterrywalker reacted to Chryco Psycho's post in the thread 8-3/4 Differential complete center section change with .I have done these set ups in the past but not enough to be expert at it , if it is set up properly there will be no whine under power or...
-
Tterrywalker replied to the thread body moldings.The straight piece in my photo is 56.5 inches long. Terry W.
-
Tterrywalker replied to the thread body moldings.Ok. I won't break anything tomorrow. I truly thought i had broke my femur or pelvis when I fell today. I need to pay closer attention to...
-
Tterrywalker replied to the thread body moldings.@booyaballer. I'm in Washington state. If you lived close to me, I'd tell ya to come over and get them. Shipping is a killer now. I'd go...
-
Tterrywalker replied to the thread body moldings.Here's a few pieces I have that follow the body lines of the Challenger. They had female plastic pieces slid into the molding channel on...
-
-
Tterrywalker replied to the thread body moldings.Very hard to find, especially the original Mopar ones. @Cudahunter may be the best source for info on them. I think he may know...
