My recently rebuilt 512 sixpack with Al. heads and a modest cam with hydraulic followers starts from cold and runs well. However sometimes when hot the (mini) starter struggles to crank the engine and it spits back through the middle carb. Allow to cool and it starts fine. Timing is set at 35...
Finally fitted my six pack to my 440. A while ago I downloaded information on tuning them (can't remember where from). One author says -
",.....I like a six pack to come in quick,....you'll have to buy 2 spring kits, replace with the "white" springs if you want a quick responding set-up,....if...
I am dealing with spots that have appeared in my paintwork on some places eg. It is on the side of the left front fender but not on top. Paint is cellulose. The pic is after rubbing down with 120 grit. Are these micro blisters? What do you think caused this. Can I paint over now or do I need to...
I did the inside of outer skin but not under the plastic panel. Will do that too. My panels are leather trimmed which probably helps. Hinges are rebuilt.
Yes, I have vapour barrier. I guess I must just go through everything and make sure it's tight and damped or insulated. The cloth on the lock/handle rods may make a difference too.
70 Challenger. I THINK I have everything assembled correctly but there is a rattle when I close them. I have new cats whiskers and the top adjustable dampers against the glass are in place. Even if I hold the glass whilst closing it still does it. Could someone please suggest what to look at to...