Vaanth's latest activity
-
Vaanth replied to the thread 73 barracuda 340 727 driveshaft question..If the drive shaft has one tapered down end, that end was installed to the rear by Chrysler, at the axle, as shown in the following... -
-
Vaanth replied to the thread 1973 Challenger Rear End.The 1973 Challenger was only available with the 8-3/4" rear axle. The only 8-3/4" axle center section in 1973 was the 2881489 housing...
-
Vaanth, just wanted to say thnx again - the pictures made the lock replacements a breeze w/o any issues
-
Vaanth replied to the thread REAR Bumper guard Lower Bolt.The rear bumper guard lower attachment bolt is a 5/16-18 with a 1/2" hex head.
-
-
Vaanth replied to the thread Door Locks.The door lock cylinders in E-bodies are the same as other car lines, but the cylinder is encased in the door handle assembly. The lever...
-
-
Vaanth replied to the thread How to identify a stdard dash harness from a Rallye?.The pictured wiring harness is for a 1974 E-body with a Rallye instrument cluster.
-
Vaanth replied to the thread How to identify a stdard dash harness from a Rallye?.The instrument cluster wiring portion branches from the main wrapped harness in the same area for both standard and Rallye clusters...
-
-
Vaanth replied to the thread Date code for alternator.Part number 3438178 is listed as originally having a double pulley for an air conditioned application. It likely has been changed, but...
-
-
Vaanth replied to the thread Date code for alternator.As Floyd notes, this alternator looks to have gone through a mass rebuilder process and the end shields (housing) were blasted, or more...
-
Vaanth replied to the thread 73 barracuda gas tank strap nut tightness?.The torque specification for the J-bolt lock nut is 50 inch-pounds (maximum). The torque specification information is in section 14...
-
Vaanth replied to the thread Holes in floor and trunk.The bulk of the holes with rubber, or sometimes plastic or metal, plugs are for drainage of the cleaning, treatment, and primer...
-
-
Vaanth replied to the thread heater box.I have no real idea about the valuation in today's market(s). To me personally, not much, as I have a good one in each car, and a couple...
-
-
Vaanth replied to the thread heater box.The pictured item is the heater box assembly for a 1972 E-body, without air conditioning. The assembly was built on Monday, September...
-
Vaanth replied to the thread Wheel Decode Help.The pictured wheel showing the number stamps was made in 1975 at Motor Wheel plant # 1. This is a 15" x 6.5" Rallye Class I wheel, part...
-
-
Vaanth replied to the thread 70 challenger 383 radiator overflow question?.The 1970 Challenger has an overflow tube from the nipple at the radiator cap opening, like other models. The tube just directs any...
