Vaanth's latest activity
-
Vaanth replied to the thread Thermoquad questions.It sounds like you have a plan. Having the before video and the after video is good. Narrow down any intended changes that might have... -
-
Vaanth replied to the thread Thermoquad questions.That is too much fuel flowing at the nozzle at idle. There are a few possible culprits. Most likely, the primary throttle plates are...
-
Vaanth replied to the thread oil filter leaking.It's likely available at several sources for the parts, but one good place for the plate, fitting, and gasket is Mancini Racing...
-
Vaanth replied to the thread oil filter leaking.The adapter plate uses a gasket around the outer edge as shown in the following image:
-
-
Vaanth replied to the thread Thermoquad questions.The 9096S Thermo-Quad could be a reasonable parts source for many of the parts on a 6166S or 6321S Thermo-Quad carburetor. The 9096S is...
-
Vaanth replied to the thread Bumper bolts.The bumper bolt threads for the face bar on a 1970 Barracuda, and most other domestic Chrysler product cars from the 60s-80s, is 3/8" x...
-
-
Vaanth replied to the thread Looking for caliper retaining clip.The sliding calipers hardware kit is available at many sources, but here are several from which to choose at RockAuto: Disc Brake...
-
Vaanth replied to the thread Question about spline count.In regard to the input spline size, the converter diameter does not matter.
-
Vaanth replied to the thread Orange box ignition wiring.Yes, the wires circled in red connect to the negative (-) terminal on the ignition coil. The gray wire with tracer from the bulkhead...
-
Vaanth replied to the thread Question about spline count.NOTE: Assuming no changes to original input shafts in the transmission in the following listing. The 1962-1966 A727 Torqueflite input...
-
Vaanth replied to the thread 1 inch lift on the back.
-
-
Vaanth replied to the thread 1 inch lift on the back.I have added Pro-Comp 13120 leafs to the rear leaf springs in place of mid-length leaf on two cars with good success. Both lifted about...
-
-
Thank you my friend.....
-
Vaanth replied to the thread Inspection Cover.The pictured inspection cover is for a small block bell housing (10.5" flywheel). Fit includes housing numbers 2843887, 2892482...
-
Vaanth replied to the thread Random E Body photos Post away!.
-
