Xcudame's latest activity
-
Xcudame replied to the thread Critters in radiator.Somewhere there is a chipmunk running around frantically looking for his nuts! 😂 -
Don't those kind of things just drive you nuts!
-
Xcudame replied to the thread Good to be Here!.Welcome to FEBO from the desert! Most 2.76 gears were open, so you may have to have one built. I attached a link to a 3.55 sure grip on...
-
Nice work on that harness, sounds like you’re doing it right! That translucent wrap you're seeing is likely fiber-reinforced PVC tape or...
-
Xcudame replied to the thread fuel adapter.As long as it runs and you can enjoy it is the main thing at this point. E-Bodies are definitely an "E" ticket ride. I can't wait until...
-
I was looking for a rubber 90 degree or something like that , I'm just gonna run it up to a filter and go , it isn't that bad of a bend...
-
Xcudame replied to the thread Harness Wrapping.What you want to make sure is whatever you use, make sure it's not the soy based crap on all the new cars! That's what rodents love to...
-
If you rotate the crank, you'll likely find others that are similar. Try it and let us know.
-
Xcudame replied to the thread Rear acle help please.I've seen a lot of Mopars that are in the 1/2" range of offset from side to side and I've heard of some being off as much as an inch...
-
Reading your description, it sounds like it's shifted 1". Have the quarter panels been replaced? Is this the original rear end? Maybe...
-
Xcudame replied to the thread fuel adapter.I bought the pre-moulded hose to use on my 98 Dakota a few years ago. A section of it might work for you cludged together 383...
-
Xcudame reacted to EW1BH27's post in the thread Radio Frequency Interference w/LED Road Lamps with.
I posted this on e-bodies.org and thought to share it here too. I did see some PAR36 bulbs that said "RFI/EMI free" but pricey and I... -
Xcudame replied to the thread Harness Wrapping.I have no idea and am interested in what others say. I have only seen black tape.
-
Can I have the hood? :D
-
Xcudame replied to the thread Value cover studs.I use two nuts to install the studs. Tighten the nuts together with two 7/16" wrenches. Then install the stud with the smallest 7/16"...