Xcudame's latest activity
-
Xcudame replied to the thread 833 question.The bell housing is obviously different, but the transmission is basically the same. As mentioned in 1972 the "Std" had this gearing... -
Yes they all fit , as long as it has the rear shifter mount on the tail housing different ratios were used over the years
-
It would generally be expected that a small block transmission would have a close gear ratio and a big block transmission would be a...
-
Xcudame replied to the thread New old guy.Welcome to FEBO from the desert! Nice collection of Mopars and hot rods!
-
Just joined today folks. Thanks for the welcome. I’ve recently retired after 49 years in the car business - the last 38 as service...
-
Xcudame replied to the thread Big block headers ?.Welcome to FEBO from the desert! Love your B7 Challenger. TTI headers are the best. Some people complain about their coatings burning...
-
Welcome to the site , Love the B7 Blue !! TTI are the best fit & quality , Dougs are a close second
-
Xcudame replied to the thread Sudden Lifter Noise.A spun connecting rod bearing makes a tap tap sound that changes with RPM. 🙁
-
I am VERY disappointed. Of all the Dudes and Military Veterans on this site, and not one rude/sarcastic comment about rear height...
-
The above info is good. I would still do both if you have a engine lift. so many times been there, done something, knew better, Would of...
-
Xcudame replied to the thread What Torque Converter.This is a pet peeve of mine! I hate that the industry rates torque converters by Stall Speed. The same basic torque converter was used...
-
Xcudame replied to the thread Oil Pan Removal on 318.Since you have an oil leak there, you might as well drop the pan. You will need to jack up the engine, being careful the distributer cap...
-
Yep! Until it hits the firewall. Drain the oil and use a USB camera.
-
Xcudame replied to the thread 360 with a 3" dual exhaust - What to expect ?.Just about zero back pressure! Be almost like running open exhaust. For a stockish small block (360 or smaller), 2 1/4" is more than...
-
Xcudame replied to the thread Front disc installation.Kind of on a side note. I have a 98 Dakota (318 magnum) that is currently on its sixth set of front disc pads and third set of rotors...