Search results for query: *

Thank you for your response. The tear was much worse looking once it came out, and am glad I changed it. Good idea, I have the backs yet to do, and will flush at the dot 3 out.

Thank you for your response. The tear was much worse looking once it came out, and am glad I changed it.

Thank you, the kits are stupid cheap on Rock Auto. Thinking about it, would you be old enough to remember how auto parts stores used to use caliper pistons as ash trays on their counters? Ours did!! :)

Accidentally dropped this Caliper and noticed a tear in the boot. Do you guys think it is acceptable for install, repairable as it sits, or fatal and must be replaced? Most kind

Pre-owned wiring harness for E Body with AC:

Thank you very much for the comments.

Thank you so very much for your comments. End play makes sense, as does the fabrication holes. I'll dress the bar and slap it back in tonight.

Thank you so very much for your comments. End play makes sense, as does the fabrication holes. I'll dress the bar and slap it back in tonight.

Hello and good day, I have a question for the group on my torsion bar installation. I have a 74 challenger, which originally came with a 318/904, and I replaced these with a 383/727. Front steering and suspension steering updates: New Upper control arms, bushings and ball joints, Have...

Thanks for your reply, didn't the Hemi K frame have such welding done to it, maybe torque boxes?

Thank you for responding!

Thanks for the ideas!!

Hello, I was starting to install my front suspension parts when I made two discoveries. An elongated strut rod hole on the left and a crack on the k frame above the right strut rod hole. Suggestions welcomed. Thanks

Hello, I had a great experience with a gallon jug of the 6x vinegar at Home Depot, for $20. The stuff is a great rust stripper, but please please wear gloves.

Thanks!

I received the LCA’s from welding on the plates, and they came out great! I had him do the washer trick and will press out the bushing housing today The rubber bumper is junk and a new one has been ordered. Any recommendations on a good chemical rust remover?

Hey man, I found this website in Prescott, AZ that makes all kinds of tabs, and sent them your drawing and photo to see if he has anything that is a match. www.tabzone.com Reinforcing plates to arrive from Mancini on Saturday. :)

Thank you Joe for responding!

Thank you!! Back in the day, I used to collect BRs when I went junkyarding, and kept them in a lunch sack in the glove box of my Duster....these came in handy!!

Thank you for the great advice. I have some Moog UCA bushings in my 'pile' and will see if they are the number you referred to. I replaced the steering box et al a couple years ago. The state of my funds at the time informed my purchase decisions. :( I like the fast Pitman/Idler arm. With...