Search results for query: *

Drums rear I have to say I agree to disagree or something to that effect. That is if that makes sense. I have to say rear drum brakes last a long time 50k with no problem. Slap on an other set and maybe some hardware.Than other 50k. I have put 100k on a set of shoes, there might have been not...

Welcome to FEBO. Let us know what you find or see!

That's why I said to pump the brakes to help put things where they wan't to be. but there has to pressure applied through the wheel cylinder that your not getting the pressure. I think it's bypassing in the conbo valve. I think as Katfish suggest plug the lines and see were you have...

When I replace the shoes. I adjust out to where there is some sort of drag. I pump the brakes for the wheel cylinder to push everything in place. Then repeat until I get the drag I want, tighten up or loosen. And yes sometime they have to be backed off a bit to get the drums off. If you don't...

It's hard to say with out any pictures. For example. Your opion of a rusted out shell and someone elses that can make something out of nothing. The person that can make somthing out of nothing. They have the skill to fix it. A peson that knows nothing but has the funds doen't care as long as...

Welcome to FEBO. That is a good start of what you have. Not a complete basket case.

I do agee with that. Give it some time to se what you really want to do. What did I miss :poke:Barracuda hood? I see challenger?

Deceptive practice. I couldn't agree more. Some if not most. The NOS are of good quality and some but few are of poor fit and finish. That's where I think a good used OEM is a better buy. Those that are reporoduing the parts. Have to give them credit for making the parts to fill a hole. Heres...

That would be correct. Lock washer.

Sound like it's good for what ales you. Mixes good with Disaronno! My Siterinlaw interduce us and we have been getting along just fine I'm only allowed on bottle a year. There are different bottle on the shelf. Please don't think I'm a sofistacaed drinker. I favor my flavors! I drank with...

Welcome to FEBO. I don't think you CUDA of done any better producing a finished product.

Column in pieces.

From another post.

This might be a start to answer your question. Dash Harness - Classic Industries or Year One? Time frame for rewiring Others may add to this from their experience.

Welcome to FEBO. The more MOPARS the merrier!

Cut the filter open. A lot of good info above. Drive like you getting on a freeway. On the ramp accelerate to get up to speed and stay there for a time as stated above you feel compatible with. Same for bringing it down so there is trust in the other direction in the engine. Not like the...

It is possible to replace a camshaft in a small block engine without removing the engine from the car, though it is significantly more labor-intensive than a drop-in swap. Most enthusiasts and mechanics report that 9 out of 10 cam changes are performed with the engine in place, provided there...

The steering column can be lowered a bit to give you a little more room. Undo the two nuts under the dash, that allows it to drop down a bit. If it's bit a chore. Remove the steering wheel 3 nuts, then there is a lot more room. Only takes a few minutes and then there is no problem getting in...

In general. If you are referring to a vehicle ignition system that starts and runs for a few seconds then dies, this is a known diagnostic scenario often linked to fuel, spark, or security system failures: Fuel System: A failing fuel pump check valve, clogged fuel filter, or bad fuel pump...

It looks as you were versed on the install. Very good work! smart move of the up grade for your needs. Just guessing. It looks like you ran the alt feed to the starter. That's good for getting the battery state of charge where it needs to be. From that point where are all the accessories...