Search results for query: *

This is what I found online..

So I put it back to where I found it.I would still like a good explanation to why they do that if anybody has one thanks

I am going to put it back the way I found it

II am wondering why they would put the taper.\nToward the rear end and should\nI put it back that way

This is how mine looked , but I switched it around the other way with the taper towards the slip yoke at the transmission.. Should I put it back the other way?\nIs the reason behind doing it the other way

That is correct.The taper end was facing the rear end...

I was changing universal joints and noticed that the slip yoke was on the bigger end of the drive shaft instead of the tapered end like i am used to seeing.. Just so happen was watching graveyard cars and noticed a barracuda.With the drive shaft the same way, the slip yoke was on the bigger end...

For some reason , it will not let me upload anymore photos.I will keep working on it

Thank you that's very helpful

Thank you...

Does anyone have any pictures of these being installed...

Ok thanks

Thank You..good read.

Just trying to figure out the best way to install these.. Any suggestions on should dos , or must dos.. Or would do if I was you l o l...

As I mentioned earlier about 3 out of 5 cars , I looked at do not have the trunk extensions and our finish and painted.. I was just curious of how they were put together where the two meet at the bottom of the quarter panel

So I have decided to put trunk extensions on my project. I have a question.\n I saw a couple of videos where the trunk extension and the quarter panel at the bottom were not welded solid together. Does anybody have a thought on how they are done or supposed to be connected to each other?The...

While installing the rear valance, I realized that There are no trunk extensions installed.. It had new quarters, and trunk floor that was already installed when I got the car.. As I was looking at pictures on the web , I noticed that about three out of every five pictures do not have trunks ...

Thanks....

Lol sorry about that.There is only two phillips heads , and I think they go in the center of the valance where the two brackets are and the other two hex screws go on each end.. I guess that's not really a question.Rather needing verification , l o l...