Search results for query: *

The TTI headers arrived, and fit as advertised. Thanks for the feedback!

Yep, I was thinking there would be places to get one without using an adapter. Thanks!

I am getting some other stuff from Cass, he doesn't list anything other than a standard slip yoke shaft on his website. I can touch base with him next week to see if he handles what I need. Thanks

Slowly working on installing the G3 hemi in my 73. Along with a million other questions, where can I get a driveshaft? I see places that sell the adapter to convert the flange to a yoke, but wondering if there is a source to use the existing flange and get a slip yoke to connect to the 8hp90...

Thanks for the reply! I would like to be closer to what you have, strictly for my personal preference. Thanks for all the great info!

Not really a pro street layout, kind of a low level pro touring deal. Just trying to determine if i can get away with moving stuff in a little to get some dish on the rims. I won't be having square tire setup. Thanks!

Thanks for the replies. Is the Dana 60 from a pickup the same center/tubes as what was in the cars? I was just curious if people normally narrowed up the rears when they do the mini tub kit. I prefer the look with a little more dish on the outside, compared to the newer vehicle setups.

Working on a 73 Challenger, installing a level 3 USCT kit in prep for a gen 3 hemi swap. Currently planning on a 9" rear to replace the 7 1/4 in the car. With the couple inches of extra room per side, is it best to go with a 4" or so narrower axle? The plan is to use a 4 link/coil over setup...

Thanks. I was looking at those, and then noticed Classic industries has a couple options, and one option seems to be the AMD one? Thanks for the response.

Looking to replace the floor in my 73 challenger before installing the frame connectors. Is there one brand that is better than the other? Or are they all from the same vendor? Thanks

The holley deal is a bummer, but it sounds like it is the result of the ownership change. Thanks for the info.

Thanks for the update! Hope you get it worked out!

Thanks for your response! It sounds like you are running into some of the same issues i have been reading about and trying to avoid. I will keep this updated when I get rolling on the project. Thanks

Working on collecting parts for a hellcat install in a 73 challenger. What options are left for headers? It looks like TTI will work with stock K member, but don't list the 8hp90 trans? I am not 100% committed to stock front end, but haven't narrowed down the coil over options enough to make...

Hi everyone. New member from North Dakota. Long time car/pickup guy, new to the Mopar world. Currently collecting parts for a gen 3 Hemi swap in a 73 challenger. Hope to learn lots here! Lance